Catálogos >
TRANBERG >
Datasheet TEF 9208 Enclosure heaterT4, 250 VAC

Datasheet TEF 9208 Enclosure heaterT4, 250 VAC
1 / 2Páginas

Excertos do catálogo

Datasheet TEF 9208 Enclosure heaterT4, 250 VAC - 1

ENCLOSURE HEATER TEF 9208 Ex e T4 240 VAC, WITH FLYING LEAD ZONE 1 , ZONE 2 & SAFE AREA Subject to change without prior notice TPS5003 REV. E 07.07.2017 Globally approved Ex e, self regulating enclosure heater. AISI 316L acid resistant steel housing. With flying lead electrical connection. Delivered with power output from 50W to 300W at 0°C. TECHNICAL DATA Ex-protection ATEX & IECEx: For use inside equipment enclosures and cabinets to prevent condensation and provide climatic control. Frost protection. Operational ambient temp.: Max. withstand ambient temp.: +50°C (Heater is energized) +80°C (Heater is deenergized) Nominal voltage: • Low profile, easy to fit inside cabinets. • Self regulating heating element. Prevents overheating. Inrush current: Electrical protection: Connect to max. 16A circuit breaker. Earth leakage protection device or isolation device, depend on type of system of earth according to IEC 364-3, chapter 31, and EN60079-7 Annex D. Electrical connection: Flying lead, For use in enclosures with IP54 or higher. Output accuracy: • Rugged AISI 316L, acid steel construction. • Low maintenance. APPROVALS AND CERTIFICATES IECEx certificate No.: IECEx NEM 11.0005X ATEX certificate No.: Nemko 11ATEX1098X CSA Certificate: CSA Master contract: 216432 EAC certificate: No TC: RU C-NO.MШ06.B.00091 Серия RU No 0007345 R. Stahl Tranberg AS E info@stahl-tranberg.com | stahl-tranberg.com Main office: Strandsvingen 6 | N-4032 Stavanger | Norway | T +47 51 57 89 00 | F +47 51 57 89 50 Office Oslo: Luhrtoppen 2 | N-1470 Lørenskog | No

Abrir o catálogo na página 1

Datasheet TEF 9208 Enclosure heaterT4, 250 VAC - 2

ENCLOSURE HEATER DESCRIPTION Part No. Enclosure heater, 50W @ 0°C DIMENSIONS *Nominal output Overall dimensions Mounting dimension Length flying lead *Note: Nominal at still air @0°C MOUNTING INSTRUCTIONS 4xØ6 mounting holes on the rear side of the heater. Hold the heater close to the installation surface, and insert the M6 screws in each of the 4 mounting holes. Use a tool to tighten the screws firmly to secure the heater. R. Stahl Tranberg AS E info@stahl-tranberg.com | stahl-tranberg.com Main office: Strandsvingen 6 | N-4032 Stavanger | Norway | T +47 51 57 89 00 | F +47 51 57 89 50...

Abrir o catálogo na página 2