Catálogos >
Sea Hawk >
Silver Bullet?

Silver Bullet?
1 / 2Páginas

Excertos do catálogo

SILVER BULLET Performance Coating Friction Reducing Performance Coating Racing Finish No Sanding Between Coats Color Stays Bright After Launch Product Description Silver Bullet is a fresh water friction reducing, low drag, high performance coating. Silver Bullet gives an immediate super smooth racing finish without the need of sanding. Use for fresh water only. Friction Reducing (Low Drag) Easily cleaned in and out of the water Color stays bright after launch No sanding between coats Best for fresh water lakes and rivers Product Information Application Controls Colors: Silver 403, Blue 402, Black 405, Red 401 Method: This product may be applied by airless and conventional spray, solvent resistant rollers and brushes. Finish/Sheen: Flat Dry Times and Overcoating Intervals: Typical Shelf Life: 2 Years Pleasure Craft Drying time in Hours Overcoat Time Solids by Weight: 34.5% Mix Ratio: 1 Quart + Zinc Dust Shipping Weight: 2.22 Lbs./Gal. Flash Point: 63°F VOC: 630 Grams/Liter Film Thickness: 1 mil dry film thickness per coat Recommended Coats: 1 coat on previously painted surface, 2 coats on bare surface. Please contact your Sea Hawk representative for Commercial Marine application and overcoating dry times. Theoretical Coverage: 85 Sq. Ft./Qt @ recommended film thickness NEW NAUTICAL COATINGS, INC. 14805 49th Street North • Clearwater, FL 33762 • 727.523.8053 • 800.528.0997 • FAX 727.523.7325 www.SeaHawkPaints.com

Abrir o catálogo na página 1

SILVER BULLET Surface Preparation Previously Painted with Similar Type Coating: Silver Bullet may be applied over properly prepared existing paints Interlux VC-17 and Pettit SR-21. Sand with 320 grit paper to remove as much existing paint as possible. Wipe down with Isopropyl Alcohol to further prepare the surface and apply 1-2 coats of Silver Bullet. Previously Painted with Hard Antifouling: Due to the porosity of hard antifouling paints; sand several times starting with 80 grit sandpaper working to the final sanding of 320 grit. Wipe down with Sea Hawk S-80, or S-90 to remove sanding...

Abrir o catálogo na página 2