Catálogos >
Sea Hawk >
Monterey Solvent Free Hard Ablative

Monterey Solvent Free Hard Ablative
1 / 2Páginas

Excertos do catálogo

Monterey Water Based Product Safer For The Environment Solvent Free Hard Ablative No More Worries About Air Pollution (Low VOC’s) Long Lasting Semi-Hard Ablative Finish Reduces Paint Buildup Tests Prove Monterey Outperforms All Other Water Borne Paints 5400 Series Product Description Monterey is Sea Hawk's solvent-free antifouling formulation that is designed to give the best protection against all types of marine fouling, while remaining friendly to the environment. Monterey is a semi-hard, ablative finish that is easy to apply. It is compatible with most paints on the market and can be applied over most existing bottom paint in good condition. Monterey can also withstand removal from water without affecting its antifouling abilities. Benefits VS. Competition Over 80% Lower VOC’s than Solvent-Based Paint Highest Grade of Cuprous Oxide Available Harder Ablative Finish (Lasts Longer on Higher Speed Vessels) Better Color Consistency for Color Matching Product Information Application Details Colors: Red 5441, Blue 5442, Green 5443 Black 5445, Dark Blue 5430 Method: Brush, Roller or Spray Finish/Sheen: Semi-Gloss Induction Time: Not Applicable Converter: One Pack Thinner: Water Copper Content: 58% All Colors Cleaner: Water Voume Solids: 44% (±2%) Pot Life: Not Applicable Solids by Weight: 76% Mix Ratio: One Pack Shipping Weight: 21-22 Lbs./Gal. Flash Point: N/A VOC: 113 Grams/Liter Film Thickness: 5 mils wet equals 2.2 dry per coat Recommended Coats: 2 Full Coats on entire hull and 3 at waterline and other high wear areas Theoretical Coverage: 450 Sq.Ft./recommended film thickness Overcoating Interval Drying time in Hours Substrate Temp. Touch Min. Max. Launch 73°F (23°C) 2 Hr 1 Hr N/A 12 Hrs 95°F (35°C) 1 Hr 1 Hr N/A 12 Hrs ———————————————————————————— Consult your Sea Hawk Representative for the system best suited for surfaces to be protected.

Abrir o catálogo na página 1

Monterey APPLICATION Apply by brush, roller or spray. Apply 5 mils wet, which will yield 2.2 mils dry per coat. Solvent Free Hard Ablative 5400 Series Equipment Brush: China Bristle Roller: Solvent Resistant Roller Cover 3/8" pile smooth to medium Prewash Roller Cover to remove loose fibers prior to use. Airless Spray: Minimum 33:1 –2 GPM ratio pump; “0.0170.026" orifice tip; 3/8" ID high-pressure material hose; 90 PSI line pressure; 60 mesh filter. Thinning If thinning is necessary, thin up to a maximum of 10%, with water only. Cleanup Clean all equipment immediately after use with water....

Abrir o catálogo na página 2