AIS 200
1 / 2Páginas

Excertos do catálogo

AIS 200 Automatic Identification System Kongsberg Seatex provides, via its AIS 200 mobile station, a technical solution that enables the identification of other vessels and navaids fitted with the VHF based AIS technology. This can be either on a stand-alone display or on the ship’s electronic chart and radar. The ability to view and identify all vessels and their courses and speed, is a major contribution towards safer navigation for the maritime community. The AIS 200 is tested according to relevant Inland Waterways (IWW) navigation standards and is approved for use on IWW. GPS Position Interface The vessel´s primary GPS receiver needs to be interfaced with the AIS and is used as the main positioning source. However, the AIS 200 also incorporates an ”all-in-view” GPS receiver which will be used as backup for the primary GPS receiver, and as timing source for the SOTDMA (Self Organized Time Division Multiple Access) protocol. Heading Interface Vessel heading as derived from the gyro compass needs to be interfaced to the AIS. This may require a gyro converter if the heading output from the gyro compass is a stepper or synchro signal and not a serial line signal which uses the NMEA data protocol for data exchange. Chart, Radar and other Interfaces AIS can be interfaced to electronic charts or radar provided that the AIS interface is supported. When interfacing AIS to radar and chart systems, AIS target information as position, heading course and speed are available to the mariner and increase reliability of received navigation data from other vessels. The AIS 200 can as well be interfaced to the vessels Gyro or THD. Easy installation The remotely installed AIS mobile station with separate display provides a simple installation solution, saving time and money. AIS Minimum Keyboard Display The AIS 200 MKD with a 4 line display is delivered as standard. VHF data communication Dedicated VHF frequencies are used for AIS data communication and the range is dependent on the height of the VHF antenna. In order to avoid interference with the ship’s VHF voice communication, the AIS VHF antenna shall be installed in accordance with IMO requirements. As the SOTDMA protocol, which utilizes time-slots for transmission and reception of data is being used, an almost unlimited number of users may operate on the system at the same time without causing interference problems. Vessels posing the potential risk of a collision are shown in red. Vessels passing safely are shown in green.

Abrir o catálogo na página 1

Features AIS 200 features - Ship name/Call sign/MMSI/IMO number - Date and time in UTC time of composition of message - Position WGS84; Latitude/Longitude degrees & minutes - Course over ground (COG) in degrees - Speed over ground (SOG) in knots and 1/10 knots - Destination/ETA - Actual maximum draught in 1/10 of meters - Ship/Cargo (Static and voyage realated data) - Length/Beam - Number of persons on board - AIS Messaging - Graphical display of AIS targets with optional MKD Technical specifications Data inputs Gyro compass: GPS main source: DGPS corrections: Blue sign switch: Power Input...

Abrir o catálogo na página 2