Perfection Plus
1 / 2Páginas

Excertos do catálogo

Perfection Plus Varnish Varnishes PRODUCT DESCRIPTION The ultimate in varnish performance, combining excellent chemical and abrasion resistance with superb gloss. The improved formulation of Perfection Plus Varnish contains UV filters to give it the longest possible life. * Up to four times longer service life than conventional 1-part varnishes * Fully compatible with oily woods like teak and iroko after adequate degreasing and substrate preparation * Chemical cure gives resistance to fuels, oil and mild acids and alkalis PRODUCT INFORMATION Colour High Gloss Specific Gravity Volume Solids Converter/Curing Agent Typical Shelf Life 488 g/kg EU Solvent Emissions Directive (Council Directive 1999/13/EC) Unit Size DRYING/OVERCOATING INFORMATION Drying Perfection Plus Varnish/Glazecoat (Professional) Note: If maximum overcoating interval is exceeded the coating must be sanded with 320-400 grade paper prior to application of Perfection Plus Varnish. PREVIOUSLY PAINTED SURFACES In Good Condition Wash down with a suitable detergent, rinse with fresh water and allow to dry. Abrade with 320400 grade (grit) paper. In Poor Condition Remove all previous coatings and prime the substrate. BARE WOOD Sand smooth with 120 grade paper, followed by 240 and finally 320 grade paper. Remove sanding dust by brushing, dusting and wiping. If wiping with solvent then allow to dry completely before applying the first coat. Prime, if required, with Clear Wood Sealer Fast Dry. If Clear Wood Sealer has been omitted thin the first coat by 20-25% with Thinner No.9. OILY WOODS e.g. Teak Must be adequately degreased (Thinners No.9 is recommended) and prepared prior to application of Perfection Plus Varnish. Ensure the surface is completely dry before applying the first coat. Sand areas that are loose or flaking with 320 grade (grit) paper. It is recommended that sanding residue is removed prior to overcoating. The use of tack rags and a reputable Wipe Down Solvent can help achieve the required level of cleanliness. BARE WOOD: Thin the first coat by 25% using recommended thinner. Then apply a minimum of 4 full coats. Alternatively apply a minimum of 4 coats of Clear Wood Sealer (first coat thinned by 25%). Then apply a minimum 2 coats of Perfection Plus Varnish. Mixing Stir individual products prior to mixing. Mix the base and curing agents of Perfection Plus Varnish together at the Please refer to your local representative or visit http://www.yachtpaint.com for further information. All trademarks mentioned in this publication are owned by, or licensed to, the AkzoNobel group of companies. © AkzoNobel 2014.

Abrir o catálogo na página 1

Perfection Plus Varnish Varnishes specified mix ratio. Add curing agent to the base, stir and leave for 10 minutes to allow bubbles to disperse. Avoid using direct from the can. Mix the amount you expect to use in a separate container. Note: Any initial cloudiness will disappear upon thorough mixing. Thinner YTA006 Thinners No.9 Thinning Mix base and curing agent first and then thin as required. Thin first coat 20-25% when applied direct to bare wood. Thin other coats as required. Cleaner YTA006 Thinners No.9 Conventional Spray Do not spray. Roller Use foam rollers. For best results when...

Abrir o catálogo na página 2