Catálogos >
International Marine >
Intertherm 50

Intertherm 50
1 / 4Páginas

Excertos do catálogo

Intertherm 50 Silicone Aluminium PRODUCT DESCRIPTION A one pack, aluminium pigmented silicone resin coating. INTENDED USES As a light reflective primer/finish for surfaces that can reach dull red heat of up to 540°C, such as exhaust stacks. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage 18 m²/litre at 25 microns dft, allow appropriate loss factors Airless Spray, Brush, Conventional Spray, Roller Flash Point (Typical) Drying Information Overcoating Data - see limitations REGULATORY DATA 495 g/lt as supplied (EPA Method 24) 509 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:04/02/2015

Abrir o catálogo na página 1

Intertherm 50 Silicone Aluminium CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Fire Resistance - Surface Spread of Flame (Exova Warringtonfire) • Fire Resistance - Marine Equipment Directive compliant Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination....

Abrir o catálogo na página 2

Intertherm 50 Silicone Aluminium APPLICATION Mixing This material is a one pack coating and should always be mixed thoroughly with a power agitator before application. Not recommended. Use International GTA007 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Airless Spray Recommended. Tip Range 0.33-0.43 mm (13-17 thou) Total output fluid pressure at spray tip not less than 112 kg/cm² (1590 p.s.i.) Conventional Spray Work Stoppages and Cleanup Thoroughly flush all equipment with International GTA007. All unused material should be stored in...

Abrir o catálogo na página 3

Intertherm 50 Silicone Aluminium LIMITATIONS Intertherm 50 is not suitable for exposure in acid or alkaline conditions. Do not over apply. Application above 40 microns dft will result in blistering when subject to high temperatures. Excessive dry film thickness may result in cracking. Dry film thickness must not exceed 25 microns. Up to 3 coats at a maximum of 25 microns per coat can be applied without the requirement of heating between coats. This provides maximum corrosion protection when it is not possible to use a zinc silicate priming system. Overcoating information is given for...

Abrir o catálogo na página 4