Catálogos >
International Marine >
INTERSHEEN 579 DATA SHEET

INTERSHEEN 579 DATA SHEET
1 / 4Páginas

Excertos do catálogo

PRODUCT DESCRIPTION A fast drying, one pack, modified acrylic finish. Modified Acrylic Finish INTENDED USES As a cosmetic finish on above water areas. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point LABOOO-White, LAK724-Storm Grey, LAL274-Red, LAL549-Signal Green, LAY999-Black ; and a wide range of colours. 8.75 m2/litre at 40 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Single Pack 23°C (Product produced and supplied in North America has a flashpoint of 26°C due to locally sourced solvents. There is no detrimental effect on product performance.) Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 518 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings

Abrir o catálogo na página 1

Modified Acrylic Finish SURFACE PREPARATIONS When used as part of an approved scheme, this material has the following certification: • Food Contact - Carriage of Grain (NOHA) Consult your International Paint representative for details. Intersheen 579 should only be applied over recommended anticorrosive primers. The primer to be used will depend upon vessel area and application location. Typical primers include: Alternative primers may be used, depending upon region. Consult International Paint. Consult your International Paint representative for the system best suited for the surfaces to...

Abrir o catálogo na página 2

Modified Acrylic Finish Airless Spray Conventional Spray This material is a one pack coating and should always be mixed thoroughly with a power agitator before Not recommended. Use International GTA007 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 176 kg/cm2 (2500 p.s.i.) Application by conventional spray is not recommended. Application by brush is recommended for small areas only. Multiple coats may be required to achieve specified film thickness. Application by roller is...

Abrir o catálogo na página 3

Modified Acrylic Finish When applying Intersheen 579 by brush or roller, care is required to prevent "pick-up" of recently applied one pack Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 3°C above the dew point. For optimum application properties bring the material to 21-27°C, unless specifically instructed otherwise, prior to...

Abrir o catálogo na página 4