Catálogos >
International Marine >
INTERLAC 678

INTERLAC 678
1 / 4Páginas

Excertos do catálogo

Alkyd Varnish INTENDED USES A one pack alkyd varnish with high gloss and good durability. For interior and exterior woodwork. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point High Gloss 834 ft2/US gal at 1 mils dft, allow appropriate loss factors Airless Spray, Brush, Conventional Spray, Roller Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 373 g/lt (3.11 lb/US gal) as supplied (EPA Method 24) 400 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

Abrir o catálogo na página 1

Alkyd Varnish SYSTEMS AND Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE Use in accordance with the standard Worldwide Marine Specifications. PREPARATIONS A" surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. NEWBUILDING/MAJOR REFURBISHMENT Ensure the wood is clean and dry prior to application. For new wood it is...

Abrir o catálogo na página 2

Alkyd Varnish Airless Spray Conventional Spray This material is a one pack coating and should always be mixed thoroughly with a power agitator before Not recommended. Use International GTA004 only in exceptional circumstances (max 15% by volume). DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 2500 psi (176 kg/cm2) Use suitable proprietary equipment. Thinning may be required. Thoroughly flush all equipment with GTA004. All unused material should be stored in tightly closed containers. Partially filled containers may...

Abrir o catálogo na página 3

Alkyd Varnish Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 5°F above the dew point. For optimum application properties bring the material to 70°F-81°F, unless specifically instructed otherwise, prior to mixing and application. Unmixed material (in closed containers) should be maintained in protected storage in accordance with...

Abrir o catálogo na página 4