Catálogos >
International Marine >
INTERFINE 629HS

INTERFINE 629HS
1 / 4Páginas

Excertos do catálogo

Modified Acrylic PRODUCT DESCRIPTION A low VOC, high performance, two pack isocyanate free cross linking acrylic finish with low solar absorption (LSA) pigmentation which provides good durability in terms of colour and gloss retention. INTENDED USES As a cosmetic finish on above water areas. For use at Newbuilding and Maintenance & Repair. PRODUCT INFORMATION Colour Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point Induction Period HYA001-LSA Lt W/work Grey. Selective shades are available in Low Solar Absorption pigmentation 7.0 volume(s) Part A to 1.0 volume(s) Part B 13.00 nfVlitre at 50 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Part A 32°C; Part B 40°C; Mixed 40°C Drying Information Overcoating Data - see limitations Substrate Temperature Note Drying and overcoating times quoted are measured at 50 microns dry, at higher film thickness times will be increased. REGULATORY DATA 212 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings

Abrir o catálogo na página 1

Modified Acrylic Interfine 629HS should only be applied over epoxy anticorrosive primers or tiecoats. The primer to be used will depend upon vessel area and application location. Typical primer/tie coats include: Consult your International Paint representative for the system best suited for the surfaces to be protected. Use in accordance with the standard Worldwide Marine Specifications. All surfaces should be fresh water washed to remove all dirt and contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and...

Abrir o catálogo na página 2

Modified Acrylic Airless Spray Conventional Spray Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances (max 5% by volume). DO NOT USE ANY OTHER THINNER. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 155 kg/cm2 (2200 p.s.i.) Use...

Abrir o catálogo na página 3

Modified Acrylic This product is not recommended for use in immersed conditions. For brush and roller application, and in some colours, two coats of Interfine 629HS may be required to give uniform coverage, especially when applying Interfine 629HS over dark undercoats and when using certain lead-free bright finish colours such as yellows and oranges. Best practice is to use a colour compatible intermediate or anticorrosive coating under Interfine 629HS. This product will not cure adequately below 5°C. For maximum performance ambient curing temperatures should be High relative humidity, fog...

Abrir o catálogo na página 4