Catálogos >
International Marine >
INTERBOND 501

INTERBOND 501
1 / 4Páginas

Excertos do catálogo

Epoxy Primer/Finish PRODUCT DESCRIPTION A high solids, hard wearing, surface tolerant, two pack epoxy primer/finish with good color retention. INTENDED USES PRODUCT INFORMATION As an anticorrosive primer/finish for decks, deck fittings, cargo holds, topsides and boottops. For use at Maintenance & Repair or On Board Maintenance. Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point Induction Period 3.00 volume(s) Part A to 1 volume(s) Part B 257 ft2/US gal at 5 mils dft, allow appropriate loss factors Airless Spray, Roller, Brush Part A 82°F; Part B 79°F; Mixed 99°F (Product produced and supplied in North America has flash points of Part A 119°F, Part B 139°F and Mixed 122°F respectively due to locally sourced solvents. There is no detrimental effect on product performance.) 15 minutes at temperatures below 77°F Drying Information Overcoating Data - see limitations Substrate Temperature 24 hrs 28 days 20 hrs 28 days 10 hrs 28 days 6 hrs 10 days REGULATORY DATA 270 g/lt (2.25 lb/US gal) as supplied (EPA Method 24) 172 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

Abrir o catálogo na página 1

Epoxy Primer/Finish SURFACE PREPARATIONS When used as part of an approved scheme, this material has the following certification: • Food Contact - Carriage of Grain (NOHA) • Food Contact - FDA Compliant: Dry Foodstuffs • Fire Resistance - Marine Equipment Directive compliant Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. When using in cargo holds, consult the Interbond 501 Cargo Hold Application Procedures. Use in accordance with the standard Worldwide Marine...

Abrir o catálogo na página 2

Epoxy Primer/Finish Airless Spray Conventional Spray Work Stoppages and Cleanup Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid...

Abrir o catálogo na página 3

Epoxy Primer/Finish For wet holds and boottops: abrasive blast clean to Sa21/4 (ISO8501 -1 : 1988) or SSPC-SP10. If oxidation has occurred between blasting and application of Interbond 501, the surface should be reblasted to the specified visual Surface defects revealed by the blast cleaning process, should be ground, filled, or treated in the appropriate manner. Apply one coat of the recommended primer. Interbond 501 must be applied within the overcoating interval specified on the primer product data sheet. Interbond 501 is not recommended for application below 50°F. For dry holds, decks,...

Abrir o catálogo na página 4