Catálogos >
International Marine >
Interbond 201 - Low Temperature

Interbond 201 - Low Temperature
1 / 4Páginas

Excertos do catálogo

Interbond 201 Epoxy Primer/Finish PRODUCT DESCRIPTION LOW TEMPERATURE A hard wearing, surface tolerant, two pack epoxy primer/finish offering corrosion protection in one coat. A temperate version of Interbond 201 is also available for use above 5°C. INTENDED USES As an anticorrosive primer/finish for decks, deck fittings and cargo holds. For use at Maintenance & Repair or On Board Maintenance. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 4.00 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 4.93 m²/litre at 150 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Flash Point (Typical) Part A 28°C; Part B 38°C; Mixed 32°C (Product produced and supplied in North America has flash points of Part A 43°C , Part B 39°C and Mixed 39°C respectively due to locally sourced solvents. There is no detrimental effect on product performance.) Drying Information Overcoating Data - see limitations Max REGULATORY DATA Substrate Temperature Stated figures for pot life, drying times and overcoating intervals are for low temperature product. For temperate product data see separate data sheet. 279 g/lt as supplied (EPA Method 24) 212 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:12/12/2014 Ref:714

Abrir o catálogo na página 1

Interbond 201 Epoxy Primer/Finish CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Food Contact - Carriage of Grain (NOHA) • Food Contact - FDA Compliant: Dry Foodstuffs • Fire Resistance - Surface Spread of Flame (Exova Warringtonfire) Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. When using in cargo holds, consult the Interbond 201 Cargo Hold Application Guidelines. SURFACE PREPARATIONS Use in accordance with the...

Abrir o catálogo na página 2

Interbond 201 Epoxy Primer/Finish APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Airless Spray Recommended Tip Range 0.53-0.84 mm (21-33 thou) Total output fluid pressure at spray tip not less than 176 - 246 kg/cm²...

Abrir o catálogo na página 3

Interbond 201 Epoxy Primer/Finish LIMITATIONS UNIT SIZE When spraying large areas, application of a brush coat is recommended over pitted or rough surfaces to ensure full penetration. Stripe coating of complex structures is recommended. Interbond 201 low temperature grade is not suitable for use in Ballast Holds. Optimum performance is achieved when Interbond 201 is applied over blasted steel. In common with all epoxy based coatings Interbond 201 will exhibit chalking of the film on UV exposure. Overcoating information is given for guidance only and is subject to regional variation...

Abrir o catálogo na página 4