Catálogos >
Hempel >
Hempatex HI-Build 46330

Hempatex HI-Build 46330
1 / 2Páginas

Excertos do catálogo

Product Data Hempatex HI-Build 46330 Description: HEMPATEX HI-BUILD 46330 is based on chlorinated rubber. Physically drying. Resistant to salt water, splashes of mineral oils, aliphatic solvents and a wide range of chemicals, but not to animal and vegetable oils or aromatic solvents. Selfprimed, or as an intermediate or finishing coat on steel structures in moderately to severely corrosive environment, including permanently submerged surfaces. Service temperature: Maximum, dry exposure only: 80°C/176°F see REMARKS overleaf Part of Group Assortment. Local availability subject to confirmation. PHYSICAL CONSTANTS: Shade nos/Colours: Finish: Volume solids, %: Theoretical spreading rate: Flash point: Specific gravity: Surface-dry: Through-dry: VOC content: Shelf life: 11480/ Grey. Flat 42 ± 2 5.3 m2/l [212.5 sq.ft./US gallon] - 80 micron/3.2 mils 32 °C [89.6 °F] 1.3 kg/litre [10.9 lbs/US gallon] 1 hour(s) 20°C/68°F 4 hour(s) 20°C/68°F 510 g/l [4.2 lbs/US gallon] 5 years (25°C/77°F) from time of production. The physical constants stated are nominal data according to the HEMPEL Group's approved formulas. APPLICATION DETAILS: Application method: Nozzle orifice: Nozzle pressure: Cleaning of tools: Indicated film thickness, dry: Indicated film thickness, wet: Overcoat interval, min: Overcoat interval, max: Airless spray / Air spray / Brush (touch up) 0.021 - 0.023 " 150 bar [2175 psi] (Airless spray data are indicative and subject to adjustment) THINNER 08080 80 micron [3.2 mils] see REMARKS overleaf 175 micron [7 mils] see REMARKS overleaf see REMARKS overleaf Date of issue: September 2020 Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult HEMPEL Safety Data Sheets and follow all local or national safety regulations.

Abrir o catálogo na página 1

Product Data Hempatex HI-Build 46330 SURFACE PREPARATION: New steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to Sa 2½ (ISO 8501-1:2007). For temporary protection, if required, use a suitable shopprimer. All damage of shopprimer and contamination from storage and fabrication should be thoroughly cleaned prior to final painting. Repair and maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water...

Abrir o catálogo na página 2