PR20
1 / 2Páginas

Excertos do catálogo

DATA SHEET EPOXY FIXING PRIMER PR20 Epoxy dual component fixing primer for all surfaces. CHARACTERISTICS This primer gives excellent adhesion to polyester, aluminium and steel, as well as good protection against corrosion. It serves as a base for epoxy treatment cycles as well as for fixing antifoulings on new polyester hulls. PREPARATION OF THE SURFACE On new aluminium or steel hulls: Sandblast the surface, dust well and apply the PR20 primer immediately. On new gel-coat: Clean with the de-waxer/grease remover DCR900, leave to dry and apply the primer. PREPARATION OF THE PAINT Mixing thoroughly mix the base and the hardener separately. Then, mixing base, hardener and thinner. Let the mixture mature for 15-20 minutes before use. Mixing ratio by volume: Base: 65 / Hardener: 35 / Thinner: 0 to 10 Thinner for spray gun, brush and roller: Thinner for PR20 (ex D200) Length of mixture's pot life: About 8 hours at 20°C. APPLICATION Apply one 40-microns layer of epoxy primer PR20 (dry film). Leave to dry 6 hours mini, 20 hours maxi before applying the epoxy undercoat SC20 or leave to dry 6 hours mini (12 hours maxi) before applying antifouling on the polyester.

Abrir o catálogo na página 1

PRECAUTIONS FOR USE Use protective gloves, solvent protective masks and clothes. Work in a ventilated area; an accumulation of solvents can catch fire if exposed to a naked flame or a spark. HEALTH AND SAFETY See data sheet This information corresponds to the actual state of our knowledge and has the sole object of informing you about our products and possible applications. It is objectively given but does not imply any guarantee by us. Our company may modify all these details at any time SOROMAP PEINTURE VERNIS ZA de Beligon – 1 Rue Maurice Mallet 17300 ROCHEFORT S/MER Tél : 05 46 88 36 13...

Abrir o catálogo na página 2