Catálogos >
GROUPE SOROMAP >
AF2 Racing

AF2 Racing
1 / 2Páginas

Excertos do catálogo

DATA SHEET PTFE SELF-POLISHING MATRIX ANTIFOULING AF2 Racing PTFE self-polishing matrix antifouling, containing no tin, with a high copper content and controlled solubility polymer based. It is recommended in order to improve slip. CHARACTERISTICS This antifouling is suitable for all surfaces: polyester, steel, wood, except for light alloy (do not apply on aluminium). Its self-polishing design allows the maintenance of a smooth and clean hull. Its period of effectiveness is proportional to the boat's speed and frequency of use. PREPARATION OF THE SURFACE On a new hull: Clean the bare polyester with the de-waxer/grease remover DCR900, leave to dry. Apply an bonding primer to improve adhesion of the antifouling (PR10 single component or PR20 epoxy dual component). On old antifouling: Clean all dirt from the surface, eliminate any surface defect (bubbles, detached areas, etc.). If the nature of the material is unknown complete removal of the old antifouling is recommended or the application of an insulating undercoat of SC10. Reminder: AF2 contains copper oxide; it must not be used on aluminium surfaces PREPARATION OF THE PAINT Mix the product well before application. APPLICATION Be sure to apply a protective strip to delimit the surface to be painted. Cover the anodes to prevent them from being covered with antifouling. Apply two 50-microns layers of antifouling AF2 (dry film), i.e. 100 microns wet for good protection. Add a third layer on sensitive zones (water line, rudder blade, etc). Leave to dry for a minimum of 4 hours before putting into the water. The results are much better when it has been left to dry for 24 hours before putting into the water. NB: To make the most of the effects of PTFE, the antifouling AF2 Racing should be applied to gun. SOROMAP PEINTURE VERNIS ZA de Beligon – 1 Rue Maurice Mallet 17300 ROCHEFORT S/MER Tél : 05 46 88 36 13 • Fax : 05 46 88 36 25 • Email : william.thomas@sor

Abrir o catálogo na página 1

PRECAUTIONS FOR USE When sanding the antifouling it is essential to wear a mask so as not to breathe in toxic dust. Use protective gloves, masks and clothes. Keep out of reach of children. HEALTH AND SAFETY See data sheet This information corresponds to the actual state of our knowledge and has the sole object of informing you about our products and possible applications. It is objectively given but does not imply any guarantee by us. Our company may modify all these details at any time SOROMAP PEINTURE VERNIS ZA de Beligon – 1 Rue Maurice Mallet 17300 ROCHEFORT S/MER Tél : 05 46 88 36 13 •...

Abrir o catálogo na página 2