E-Plex 356DRIM
1 / 4Páginas

356DRIM Series Dual Relay Input Module Introduction The E-Plex 356DRIM is a flexible input and output module consisting of 2 normally open relay outputs and 4 digital inputs. Each digital input is configurable as either active high or active low through the E-Logic software. For output relays, status LEDs are red when relay is closed. For digital inputs, status LEDs indicate green for active high input, red for active low input. Key Features Design Specifications • 2 relay outputs • Shock: Mil Std 202 Method 213 test condition • inputs, configurable as active high or low 4 • ibration: Tested to Lloyds Register Approval V Vibration Test 2 • utput relay contacts rated for 10 amps AC or 5 O amps DC • oisture resistance: IP54 M • tatus LEDs for inputs and outputs S • CB characteristics: UL94V-0 P • Ideal for controlling generators • gnition protection: UL 1500 compliant I • LEN value 12 • perating Temperature: -40°C to 60°C O • torage Temperature: -40°C to 85°C S • perating Humidity: 0% to 100% (condensing) O • eight: 4.8oz (136g) W Powering systems - Empowering designers

356DRIM Series Electrical Specifications Description Minimum Nominal Maximum Absolute Max (Surge) Voltage 7 Volts DC Current 20 milliAmps (idle) 12 / 24 Volts DC 32 Volts DC 45 Volts DC — 120 milliAmps (full load) — Input Low Threshold 0 Volts — 0.6 Volts — Input High Threshold 7 Volts — 30 Volts — Output Relay Contact Rating (120 / 240VAC) — — 10 Amps — Output Relay Contact Rating VDC — — 5 Amps — Typical Wiring Diagram Relay 1 N.O. Relay 1 COM Relay 2 N.O. Relay 2 COM Relay 1 Status Relay 2 Status E-Plex + E-Plex Activity LED1 1 2 3 4 Digital Inputs & Status LEDs E-Plex – Status LEDs:...

Dimensional Specifications MOUNTING HOLES Mounting Specifications Screw assembly to a flat mounting surface in 2 places, as shown in the illustration. Mounting Instructions Imperial (English) fasteners: Use #10 size screw, #10 split lock washer, #10 washer. Torque to 20-22 in-lb. Do not exceed this torque as it could cause damage to the electronics. Metric fasteners: Use M5 size screw, M5 split lock washer and M5 washer. Torque to 250-280 N-cm. Do not exceed this torque as it could cause damage to the electronics. Ordering Information Powering systems - Empowering designers

Powering Systems - Empowering Designers George Summers Close, Medway City Estate, Rochester, Kent ME2 4EL tel: +44 (0)1634 778704 Fax: +44 (0)1634 290773 email: sales@e-plex.co web: www.e-plex.co Important Notice: E-Plex Ltd. (E-Plex) reserves the right to make changes to or discontinue any product or service identified in this publication without notice. E-Plex advises its customers to obtain the latest version of the relevant information to verify, before placing any orders, that the information being relied upon is current. E-Plex assumes no responsibility for infringement of patents or...