SBS/MBS
1 / 4Páginas

SBS/MBS Galvanized boat stand SBS Top of Marine plywood for higher strength. Rod and adjustment nut in solid steel. Hot dipped. Hot dipped. Steinless screws with locking nut. Rod and adjustment nut in solid steel. Hot dipped. Rod and adjustment nut in solid steel. Hot dipped. Stackable, adapted similar products on the market.

The number of stands is determined by weight, weight distribution and length of the boat. Use a wide, large sized block as keel support both in the front and back of the keel. An extra pair of stands should be used on a boat with the rig raised. Select type of stand to enshure equal adjustment for the Acme thread in both directions. Type of stand is determined by: Draft + height of keel support - approximately 0,25 m = height of stand. 1. Large top/Orange 2. Medium top/Grey Rod 27" Rod 23"

• The type of stand is determined by keel support and shape of the hull. MBS is used for flat bottom. SBS is to be used for all other hull shapes (eg for the bow or sharp V-shaped hulls). • The number of stands is determined by weight, weight distribution and length of the boat. • Use KS3, KS4 or large sized blocks as keel support. • Select type of stand to enshure equal adjustment for the Acme thread in both directions. 1. Large top/Orange 2. Medium top/Grey 3. Small top/Blue 4. Not stackable Rod 27“ Rod 23“ Rod 16“

User guide •B oat stands should only be used on firm surface where surrunding conditions (like weather) never affect the stability. • osition the stands according to the boat manufactuers recomendations, normaly a pair of P stands for every 2,6–3,3 meter (8–10 feet). • he entire weight of the boat should be borne by the keel support, not by the stands. T • he keel support should be placed depending on the weight distribution of the boat. T • afety chain should always be used to secure the stands to each other. S • ever tie anything to the stands (like cover). In heavy wind the stands might...