Catálogos >
Alfa Laval Mid Europe >
Plate heat exchanger

Plate heat exchanger
1 / 2Páginas

Excertos do catálogo

Plate heat exchanger General heating and cooling duties. Heating by means of steam. Standard design The plate heat exchanger consists of a pack of corrugated metal plates with portholes for the passage of the two fluids between which heat transfer will take place. The plate pack Is assembled between a fix frame plate and a movable pressure plate and compressed by tightening bolts. The plates are fitted with a gasket which seals the interplate channel and directs the fluids Into alternate channels. The number of plates is determined by the flow rate, physical properties of the fluids, pressure drop and temperature pro- gram. The plate corrugations promote fluid turbulence and support the plates against differential pressure. The plate and the pressure plate are suspended from an upper carrying bar and located by a lower guiding bar, both of which are fixed to a support column. Connections are located in the frame plate or, if either or both fluids make more than a single pass within the unit, in the frame and pressure plates. Typical capacities Liquid flow rate Up to 50 kg/s (800 gpm), depending on media, permitted pressure drop and temperature program. Water heating by steam Plate types M10B, M10M and M10BD, double wall plates. Frame types Working principle Channels are formed between the plates and the corner ports are arranged so that the two media flow through alternate channels. The heat Is transferred through the plate between the channels, and complete counter-current flow Is created for highest possible efficiency. The corrugation of the plates provides the passage between the plates, supports each plate against the adjacent one and enhances the turbulence, resulting In efficient heat transfer.

Abrir o catálogo na página 1

STANDARD MATERIALS Frame plate Mild steel, Epoxy painted Carbon steel Metal lined: Stainless steel, Titanium Rubber lined: Nitrile, EPDM Stainless steel Alloy 316/Alloy 304, Titanium, Alloy 254 SMO, Gaskets (Clip-on, glued) M10B Nitrile, EPDM, HNBR, EPDMF, Viton®G, AL-EPDM M10M Nitrile, EPDM, HeatSeal F™, HNBR, EPDMF, Viton®G, AL-EPDM TECHNICAL DATA Pressure vessel codes, PED, ASME, pvcALS™ Mechanical design pressure (g) / temperature *) Frame FG also approved for 1.2 MPa / 200°C to allow use In steam systems without safety valves. The number of tightening bolts may vary depending on...

Abrir o catálogo na página 2