Zeta Bonding Paste 1100 is a single-component thixotropic paste developed to bond teak decking. Zeta Bonding Paste 1100 is a polyurethane bonding paste which cures on moisture. Zeta Bonding Paste 1100 has a long open time. The paste is suitable to bond composite decks, GRP, plywood, steel, and aluminum. Zeta Bonding Paste 1100 can be used in temperatures from 10 C° to 35 C°. Apply the paste with a notch spreader depth between 4 to 5 mm. Minimum skin layer thickness 2 mm. Skin time 75 minutes, depends on weather conditions. Make sure that there is sufficient pressure on the panels until fully cured. Zeta Bonding Paste 1100 is not suitable for window bonding. Surface must be vacuum cleaned, dry, and free from grease. GRP, composite, plywood, metal and aluminum must be primed and sanded with grit 40. Zeta recommends priming before bonding. The Zeta Primer 550 is recommended for teak. Apply the primer on the teak panels, install the panels within 24 hours. Bonding composite panels or non-absorbing surface, use the Zeta Primer 660. Keep Zeta Bonding Paste 1100 in a controlled and dry environment to maximize the shelf life. Store in temperatures between 5 C° and 25 C°. 1 liter Zeta Bonding Paste covers 1 mm per 1 m2. Shelf life 12 months from manufacture date. Health and safety information Zeta advises to read the SDS and carefully follow the instructions. How to use Zeta Bondig Paste 1100 in warm climate At 30-35 C° approximately 35 minutes open time. Very hight humidity: 25 to 30 minutes open time. Low humidity: about 40 minutes open time. Perform a small-scale glue test on a discreet are to verify compatibility and bond strength. Zeta Marine Group ApS, Gotlandsvej 4 DK 5700 Svendborg Tel +45 62201312 www.zetamarinegroup.com