Catalogs >
Underwater Lights - Sea Vision >
SV55 LED GEN II Surface Mount

SV55 LED GEN II Surface Mount
3Pages

Catalog excerpts

he brightest surface mounted underwater light currently available. The slim line robust aluminum bronze housing incorporates the latest High Density LED chip technology which together with the proven borosilicate glass lens guarantees years of trouble free usage. This light is suitable for any small to mid-sized boat requiring a DC powered underwater light. SV55 LED GEN II technical specifications Application for: GRP / fiberglass / wood hulls –––––––––––––––––––––––––––––––––––––––––––––– Lamp: High density LED array –––––––––––––––––––––––––––––––––––––––––––––– Available in: White, Blue –––––––––––––––––––––––––––––––––––––––––––––– Life length: Approx 40,000 + hours –––––––––––––––––––––––––––––––––––––––––––––– Kelvin colour temp: 5000 Lumens: 4660 –––––––––––––––––––––––––––––––––––––––––––––– Glass lens: Borosilicate glass Thickness: 0.24” / 6mm Diameter: 2.7” / 70mm –––––––––––––––––––––––––––––––––––––––––––––– Power supply: 12/24 VDC – 2.0 Amps 24V / 4.2 Amps 12V –––––––––––––––––––––––––––––––––––––––––––––– Casing material: Marine Bronze Dimensions: Diameter: 3.94” / 100mm Depth: 0.8” / 21mm –––––––––––––––––––––––––––––––––––

Open the catalog to page 1

LOW PROFILE SURFACE MOUNT LED Introduction: Congratulations on the purchase of your new low profile surface mount LED array light (Patent Pending). Underwater Lights® USA, LLC takes pride in providing well designed, high quality and thoroughly tested lights that allow you to “enhance your boating experience”. These lights can be installed in your vessel for aesthetics, to attract fish and/or for security and safety. General Operating Information: The latest commercial grade “COB” High-Density Light Emitting Diode (LED) technology used in this light will provide robust and reliable operation...

Open the catalog to page 2

LOW PROFILE SURFACE MOUNT LED Installation: This light should be installed at least 125-150mm (5-6”) below the water line by qualified/approved personnel using proper tools and materials. The placement of surface mounted underwater lights on the hull bottom or sides is not recommended. After selecting a flat mounting surface on the vessel hull, drill a 12mm (1/2”) diameter hole for electrical cable routing. Apply marine grade sealant to back of light, then attach using three Phillips Flat Head Screws (9). Note: Depending upon mounting surface material, three small pilot holes may be...

Open the catalog to page 3