his light has a single high powered LED in a bronze/nylon housing designed for smaller boats that want LED lighting. This light is excellent for any boat which has limited interior access but desires a surface mount installation. Patent Pending SV54 technical specifications Application for: GRP / fiberglass –––––––––––––––––––––––––––––––––––––––––––––– Light source: LED available in white, blue, green and red –––––––––––––––––––––––––––––––––––––––––––––– Life length: Approx. 30,000 hours –––––––––––––––––––––––––––––––––––––––––––––– Kelvin colour temp: 6500 Lumens: 215 –––––––––––––––––––––––––––––––––––––––––––––– Glass lens: Convex crown borosilicate glass –––––––––––––––––––––––––––––––––––––––––––––– Thickness: 0.51” / 13mm –––––––––––––––––––––––––––––––––––––––––––––– Power supply: 10 – 32 VDC -0.25 Amps 24V/0.43 Amps 12V –––––––––––––––––––––––––––––––––––––––––––––– Casing material: Marine Bronze and black nylon Dimensions: 2.95” / 75mm x 1.24” / 31.5mm –––––––––––––––––––––––––––––––––––––––––––––– Recommended at minimum 6” (150mm) below waterline between 3 – 6 feet (1 – 2 meters apart). Fasten to a flat surface by way of 3 screws. The placement of surface mounted underwater lights on the hull bottom or sides is not recommended. ——————————————————————— All information is subject to change without prior notice, please conrm details prior to ordering. 1881 W State Road 84, Bay 102, Fort Lauderdale, FL 33315 USA T. 954 760 4447 Toll Free 1 866 772 0130 F. 954 525 3261 [email protected] www.seavision.com

SURFACE MOUNT, LED ARRAY, 10-32VDC Congratulations on the purchase of your new surface mount LED underwater light. Underwater Lights® USA, LLC takes pride in providing well designed, high quality and thoroughly tested lights that allow you to "enhance your boating experience". These lights can be installed on your vessel for aesthetics, to attract fish and/or for security and safety. General Operating Information: The commercial grade Light Emitting Diode (LED) technology used in this light will provide robust and reliable operation under normal operating conditions. This light is not equipped...

SURFACE MOUNT, LED ARRAY, 10-32VDC Installation: Always disconnect and lock-out power before working on light. This light should be installed at least 125-150mm (5-6”) below the water line by qualified/approved personnel using proper tools and materials. Important! If the light will be continually submerged for more than a few days, antifouling paint must be applied to protect it from marine growth. After selecting an appropriate mounting surface, drill a 6mm (1/4”) diameter hole for electrical cable out back cable routing ( (electrical cable out the top is optional). Apply marine grade sealant...