he SV19 is our brightest DC powered thru hull light. Incorporating the latest in high density LED COB chip technology and silicone optics produces an amazing underwater lighting effect suitable for small to mid-sized boats. The robust aluminum bronze housing and borosilicate glass lens will ensure the safety of your boat and provide many years of satisfying use. Available in blue or white. SV19 LED GEN II technical specifications Application for: GRP/fiberglass/wood hulls Angles available: Flush High density LED array Life length: Kelvin colour temp: 6500 Lumens: 3142 Total Total shipping weight: 3.4 kg / 7.5 lbs Glass lens: Borosilicate glass Thickness: Diameter: Recommended at least 6” (152mm) below the waterline between 3 – 6 feet (1-2 meters apart) (80mm) Power supply: white, blue Casing material: Dimensions: Marine Bronze / Marine Aluminum Diameter: 110mm (4.3”) Body length: 222mm (8.7”) All information is subject to change without prior notice, please confirm details prior to ordering. 1881 W. State Road 84, Bay 102, Fort Lauderdale, FL 33315 USA T. 954 760 4447 Toll Free 1 866 772 0130 F. 954 525 3261 [email protected] www.se

Thru-Hull Mount, LED Array Introduction: Congratulations on the purchase of your new thru-hull LED underwater light. Underwater Lights® USA, LLC takes pride in providing well designed, high quality and thoroughly tested lights that allow you to “enhance your boating experience”. These lights can be installed on your vessel for aesthetics, to attract fish and/or for security and safety. General Operating Information: The latest commercial grade “COB” High-Density Light Emitting Diode (LED) technology coupled with silicone optics used in this light will provide robust and reliable operation under...

Thru-Hull Mount, LED Array Installation: This light should be installed at least 152mm (6”) below the water line by qualified/approved personnel using proper tools and materials. The minimum hull thickness is 8mm (0.31”) and maximum (for sufficient heat dissipation) is 73mm (2.87”) with an access area of at least 140mm (5.5”) left behind the light for LED array servicing and general ventilation. After selecting a flat surface, cut a 80mm (3-1/4”) diameter hole through the vessel hull in the desired location. Caution! Check that no electrical wiring, fuel lines, oil lines, water lines etc., pass...