he Sea Vision SV 16 model utilizes a durable off road halogen lamp with 12 or 24 volt DC power and can be installed in the transom or the hull. Generally it should be installed in smaller boats and for the occasional light user. The vessel must be hauled out for installation although lamp change and any maintenance can be done in the water from within the hull. SV16 technical specifications Application for: GRP/fiberglass/wood hulls ——————————————————————— Lamp: 85 watt, 12 volt / 70 watt, 24 volt ——————————————————————— Life length: approx. 2,500 hours plus ——————————————————————— Lumens: 85 watt - 1,750 / 55 watt - 1,500 ——————————————————————— Kelvin colour temp: 3000 ——————————————————————— Glass lens: Borosilicate glass ——————————————————————— Thickness: 9.5mm / 0.38” ——————————————————————— Power supply: 12 VDC 7 amps running current 24 VDC 3 amps running current ——————————————————————— Casing material: Marine Bronze Dimensions: 80 mm (3.15”) x 144mm (5.67”) ——————————————————————— Angles available: Flush ——————————————————————— Weight: 700g/1.9lbs ——————————————————————— Code: SV16 ——————————————————————— Total shipping weight: 1.5 Kg / 4 lbs ——————————————————————— Installation: Recommended at minimum 6” (152 mm) below waterline between 3 - 6 feet (1 - 2 meters) apart. (60mm) 2.36” cut out hole ——————————————————————— Note: Please specify voltage when ordering. All information is subject to change without prior notice, please confirm details prior to ordering. USCG Ignition Protected 1881 W State Road 84, Bay 102, Fort Lauderdale, FL 33315 USA T. 954 760 4447 Toll Free 1 866 772 0130 F. 954 525 3261 [email protected] www.seavision.com

Introduction: Congratulations on the purchase of your new thru hull light. Underwater Lights® USA, LLC takes pride in providing well designed, high quality and thoroughly tested lights that allow you to “enhance your boating experience”. These lights can be installed in your vessel for aesthetics, to attract fish, for security and safety. General Operating Information: The commercial grade Halogen lamp used in this light will provide robust and reliable operation under normal operating conditions. The light can be operated for a brief period of time when the vessel is out of the water, but, it...

Installation: This light should be installed at least 125-150mm (5-6”) below the water line by qualified/approved personnel using proper tools and materials. The minimum hull thickness is 10mm (0.4”) and maximum is 70mm (2.75”) with an access area of at least 100mm (3.9”) left behind the light for lamp servicing and general ventilation. After selecting a flat surface, cut a 60mm (2-3/8”) diameter hole through the vessel hull in the desired location. Caution! Check that no electrical wiring, fuel lines, oil lines, water lines etc., pass near or through the intended hole location. Remove numbers...