Catalogs >
Underwater Lights Limited >
UL Ti MATE 80 20 WATT LED

UL Ti MATE 80 20 WATT LED
5Pages

Catalog excerpts

Fiberglass / Wooden underwater lights limited Manufacturer of the original underwater lights Brand marine lighting products since 1991. *The UL Ti MATE 80-20 LED is a “ Screwed Thru-Hull” underwater light which features xture, the internal LED heat Sink can be easily removed for servicing and upgrades without the hassle of hauling your boat. LED is recommended for GRP/Fiberglass and Wooden hull boats up to 20 meter. *The light must be installed below the waterline and the boat must be hauled out for installation. *Distance between lights can vary from 1m (transom) to 3 meters (port & starboard) apart for the best illumination. *With complete Lloyd’s Register Approval on all components, the UL Ti MATE 80 has been installed on a large number of smaller boats in the world. Control Options Borosilicate Glass Green een Installation Installation Thru- Hull Boat size Beam Angle Installation Angles Color Green Min-Max Operating Voltage Typical LED Life Expectancy Part Number Driver Type Driver Output Control Options Physical Length of fixture Profile (height) of fixture Removal Space Required Total weight Cable Length Hole Cut-out 5083 Aluminium / Armor Coated AB2 Bronze Lens Max Hull thickness Your Local Dealer © 2015 Underwater Lights Limited All Rights Reserved. Underwater lights limited reserves the right to change specifications without notice. *With 1,400 lumens of light power and it’s 60 degree beam angle, the UL Ti MATE 80-20 Hull Material The Great Dunton Forge, London Road Dunton Green, Sevenoaks, Kent TN13 2TD UK T: +44 (0) 1732 455753 • F: +44 (0) 1732 743233 E: uwl@underwaterlights.com www.underwaterlights.com VAT NO: 556 4425 31

Open the catalog to page 1

Open the catalog to page 2

UL Ti MATE 80 Alu-Bronze ‘submersible through hull light’ 20 Watt LED UL Ti MATE 80 Installation (Maximum hull thickness of 65mm) and Operation. Qualified/Approved personnel must be used to carry out installation. Before cutting a hole in the hull, check the hull wall thickness is not greater than 65mm and that the location of the holes are below the waterline. After cutting and finishing the hole surface, check the ‘body’(5) can be inserted into the 60mm diameter hole. You are now ready for installation. Note for cored hulls - After cutting, the exposed surfaces of the hole must be...

Open the catalog to page 3

- VE BLACK + VE RED POWER SUPPLY 12 VOLTS DRIVER 24 VOLTS DRIVER MAXIMUM 2 LAMPS ON THE SAME SUPPLY CABLE. THE 12-24 VDC DRIVER CAN OPERATE BETWEEN MIN 10 VDC 10.5 (-5%) 28.5 (+ 5%) MAX 30 VDC

Open the catalog to page 4

<]NSl LIATED) BARRE LJINIIZIEFIWATEFI LIGHT BOINIOIINIIZ; T RIVET IS USED TO MAKE THE ELECTRICAL CONNECTION FRONT FACE TO ENSURE THAT THE FRONT FACE IS BONDED BY VESSEL CATHODIC PROTECTION SYSTEM WHEN THE LIGHT IS INSTALLED A TEST CAN BE MADE TO ENSURE SMALL AREA OF THE ANODISING WHEN THE BONDING SCREW HAS BEEN TIGHTENED SUFFICIENTLY METER IS USED TO MEASURE THE SHOUD BE ZERO OHMS. IF IT DOES NOT THEN TIGHTEN THE BONDING SCREW FURTHER UNTIL THERE IS ZERO RESISTANCE MEASURED INSTALLATION PICTURE SHOWING BONDING TERMINAL AND ANODE REMOVE A SV1AI.1. PART OFTHE ANODISING FROM THE BARREL TO...

Open the catalog to page 5