Catalogs >
Underwater Lights Limited >
UL Ti MATE 130

UL Ti MATE 130
4Pages

Catalog excerpts

Fiberglass / Wooden underwater lights limited Manufacturer of the original underwater lights Brand marine lighting products since 1991. * xture, the internal part with lamp can be easily removed for servicing and upgrades without the hassle of hauling your boat. *The light must be installed below the waterline and the boat must be hauled out for installation. *Distance between lights can vary from 1.5m (transom) to 5 meters (port & starboard) apart for the best illumination. *The internal (Super Adjustable) unit allows the beam angle to be varied from a narrow to wide beam, and to universally move the beam direction by 20 degrees from inside housing. *With complete Lloyd’s Register Approval, and ABS Design Appraisal on all components, the UL Ti MATE 130 SA has been installed on some ten thousand of sh boats and motor y yachts world wide. Maintenance Control Options Installation Installation Thru- Hull SpecSheet_UL75Fixed150_010115v1 Boat size Beam Angle Installation Angles Part Number Technical Lumens Typical Bulb Life Expectancy Min-Max Operating Voltage Ballast Output Control Options Physical Length of fixture Profile (height) of fixture Removal Space Required Total weight Cable Length Hole Cut-out 5083 Aluminium / Armor Coated AB2 Bronze Your Local Dealer © 2015 Underwater Lights Limited All Rights Reserved. Underwater lights limited reserves the right to change specifications without notice. UL Ti MATE 130 SA 150W/250W is recommended for GRP/Fiberglass and Wooden hull boats 25m +. Hull Material *With maximum of 19, 000 lumens of light power and it’s 100 degree beam angle, the The Great Dunton Forge, London Road Dunton Green, Sevenoaks, Kent TN13 2TD UK T: +44 (0) 1732 455753 • F: +44 (0) 1732 743233 E: uwl@underwaterlights.com www.underwaterlights.com VAT NO: 556 4425 31

Open the catalog to page 1

Open the catalog to page 2

UL Ti MATE 130 SA ‘submersible through hull light' ORDERING NUMBERS 250 WATT LIGHTS - 230V. S00475-SA-V2W1. 150 WATT LIGHTS - 120V. S00475-SA-V3W2. 230V. S00475-SA-V2W2 UL Ti MATE 130 SA INSTALLATION (The UL Ti MATE 130 SA should be no less than 250mm/10” below the water line) Qualified/Approved personnel must be used to carry out installation Cut and prepare a 4 inch / 100 mm clearance hole for the body (16). Coat the flange of the body and the area around the hole with 3M 4200FC sealant then slide the body into the hole. From the inside fit the compensating ring (17) and screw the...

Open the catalog to page 3

and UL Ti MATE UNDERWATER LIGHT BONDING TES' FOR THE SO AND 130 LIGHTS DURING OUR PRODUCTION A RIVET IS USED TO MAKE THE ELECTRICAL CONNECTION BETWEEN THE BARREL AND FRONT FACE TO ENSURE THAT THE FRONT FACE IS BONDED BY THE BONDING SCREW TO THE VESSEL CATHODIC PROTECTION SYSTEM WHEN THE LIGHT IS INSTALLED A TEST CAN BE MADE TO ENSURE ALL IS CORRECT. REMOVE A SMALL AREA OF THE ANODISING AS SHOWN TO EXPOSE THE ALUMINIUM REMOVE ASM ALE DART OFTHE ANODISING FROM TEIE BARREETO EXPOSE THE ALUMINIUM FOR TESTING THE BONDING CONNECTION WHEN THE BONDING SCREW HAS BEEN TIGHTENED SUFFICIENTLY TO BREAK...

Open the catalog to page 4