underwater lights limited Manufacturer of the Original underwater lightsTM Brand Marine Lighting Products Since 1991 75 HP cute on size big on light 50 FLUSH INSERT EXPLODED VIEW VIEW SHOWING THE PLUG AND PLAY 50 DEGREE INSERT PLEASE REGISTER YOUR PRODUCT WARRANTY DIRECT TO WWW.REGISTER-UWL.COM For sales telephone numbers visit www.qtled.com THE QT-LED RANGE IS DESIGNED AND MANUFACTURED BY UNDERWATER LIGHTS LTD IN THE U.K. For sales and information visit WWW.QTLED.COM TECHNICAL SPECIFICATION Lamp type - LED 18,500 lumen, 6,500K and RGB+W Lamp life - 40,000 hours @ 35C Driver power supply - 110/240 vac, Power 130 watts. Inserts - 5083 Aluminium & 316L Stainless Steel. Insert Lens - Coated Borosilicate glass Driver output - 4 channel 36vdc/1.4amps per channel DMX Control - For dimming and colour change Driver and DMX supplied in Aluminium IP 67 Enclosure NOTE Installation Instruction: Maximum hull plate thickness should be 12mm for the ush Plus and 20mm for the 50 degree. Electrical Information: Driver - Driver must be tted minimum 60 cm above tank top with good ventilation. Cable - The QT 75 HP is supplied with 3 meters of cable with a plug ready to plug into the driver enclosure socket. DMX cable is ordered separately. For additional information please visit our web site. CUTE ON SIZE - BIG ON LIGHT DESCRIPTION The Qt LED 75 HP is a “through-hull” submersible marine light for welding into steel or aluminium hulls. The Qt LED 75 HP is maintained from inside the yacht. Dry docking is not necessary. The LED heat sink /body is easily removed and replaced from the insert. The light uses our existing standard insert design. We advise that the light be installed minimum 250mm below the waterline when the yacht is loaded with 50% fuel and 50% water, and that the light be angled 15 degrees downwards. To achieve this there are two models Flush + and 50 degree. The high powered LED (18,500 lm) is available in cool white (6,500K) and four channel RGB+W. The LED has a wide beam of around 90 degree .

underwater lights limited Manufacturer of the Original underwater lightsTM Brand Marine Lighting Products Since 1991 75 HP * LENS FITTING INSTRUCTIONS-Remove the blanking plate and check the insert (1) lens landing surfaces are clean and apply a suitable silicone grease to the gaskets (2). Fit the lens (3), gaskets (2) and lens retaining ring (4) . Hand tighten the cap head bolts (6) and spring washers (5) making sure the lens retaining ring is square. Torque the bolts to 6 Nm (4.5ft/lbs) in the sequence shown below, check the ring again and re-torque the screws again to the same setting. * LED...