Catalogs >
Underwater Lights Limited >
QTLED 130 Standard

QTLED 130 Standard
2Pages

Catalog excerpts

underwater lights limited Manufacturer of the Original underwater lightsTM Brand Marine Lighting Products Since 1991 TECHNICAL SPECIFICATION Lamp type - LED 10,000 lumen, 7,200K and Royal Blue Lamp life - 40,000 hours @ 35C Driver power supply - 110/240 vac, Power 120 watts. Body - 5083 Aluminium & AB2 Insert Lens - Coated Borosilicate glass Driver output - 32 vdc, 3,3 amps DMX Control - Can be tted to driver Driver and DMX supplied in Aluminium IP 67 Enclosure NOTEInstallation Instruction: The hole cut-out should be 101mm. Hull thickness range 12mm to120 mm. For Lamp Maintenance allow 170mm behind the cover. Electrical Information: Driver - Driver must be tted minimum 60cm above the tank top with good space for ventilation. Cable - The QT 130 is supplied with a 3 meters of cable with a plug ready to connect to the socket in the driver IP 67 enclosure. For additional information please visit our web site. EXPLODED VIEW REMOVE BOTH RINGS TO INSTALL PLEASE REGISTER YOUR PRODUCT WARRANTY DIRECT TO WWW.REGISTER-UWL.COM For sales telephone numbers visit www.qtled.com THE QT-LED RANGE IS DESIGNED AND MANUFACTURED BY UNDERWATER LIGHTS LTD IN THE U.K. For sales and information visit WWW.QTLED.COM DESCRIPTION The Qt LED 130 is a ush “through-hull” submersible marine light for large yachts and is designed for GRP-Fibreglass and wooden hulls. We advise that the light be installed 250mm below the waterline. Maintenance of the light is carried out from inside the hull. Dry docking is not necessary. The QT LED 130 comes fully assembled and ready for installation when the securing and compensating rings are removed. The LED is easily removed and replaced from the projector barrel. The LED has a wide beam of around 87 degree . The standard LED colour used is cool white but the light is also available on request with a Royal Blue LED chip. CUTE ON SIZE - BIG ON LIGHT cute on size big on light

Open the catalog to page 1

underwater lights limited Manufacturer of the Original underwater lightsTM Brand Marine Lighting Products Since 1991 130 *FITTING THE BODY- Qualied/Approved personnel must be used to carry out installation. Cut and prepare a 4 inch / 100 mm clearance hole for the body (1). Coat the ange of the body and the area around the hole with 3M 4200FC or Sikaex 291sealant then slide the body into the hole. From the inside t the compensating ring (2) and screw the securing ring (3) up “hand tight”. Adjust the screws (5) so the compensating ring is ush to the hull and check the sealant has owed...

Open the catalog to page 2