
Ömerli Mah. Arpaçay Sok. No:4 34555 Arnavutköy / İstanbul / TÜRKİYE, Tel.: +90(212) 482 41 61, E-mail: [email protected] ULTRA Anchor USER GUIDE ABS Type Approved Boyut Makina San. ve Tic. Ltd. Şti. DBA ULTRA Prod
Open the catalog to page 1ULTRA Anchor User Guide - 2 The ULTRA Anchor represents the result of years of design refinement, prototype development, and extensive testing. Across the world, countless satisfied boat owners have trusted the ULTRA Anchor in diverse seabed conditions and even in severe weather, proving its outstanding quality, reliability, and strength. The ULTRA Anchor is operated like any conventional anchor. Its unique design features are explained in the FAQ section. ULTRA Anchor User Guide -1 Congratulations on your purchase of the ULTRA Anchor. ANCHOR DEPLOYMENT (DROPPING ANCHOR) - Decide where to anchor....
Open the catalog to page 2ULTRA Anchor User Guide - 4 - Approach your desired location and head up into Chain Lenght Scope = = Beaufort Depth the wind and current until the boat's forward motion has stopped. - When your boat's speed is zero, open the gypsy -If you notice you're getting too close after the anchor digs in for comfort to other boats or hazards, you can pull the chain in to increase your distance. This will decrease your scope; the remaining scope should never be less than three times the depth (total depth from the bow roller to the sea bed). - If you plan on staying at anchor for the night or the wind increases,...
Open the catalog to page 3ULTRA Anchor User Guide - 6 -Start the engine and operate the windlass, don't use the windlass motor to pull the weight of the boat towards the anchor; Instead, move the boat slowly forward along the chain using slow movements on the throttle, and at the same time, operate the windlass to recover the chain. -When the bow is above the anchor, the chain will tighten for a short time pivoting the ULTRA Anchor on the pivot plate, helping dislodge the anchor from the seabed. Recover the remaining chain and dock the anchor correctly on the bow roller. POLLUTIONS: -Stainless Steel: While your ULTRA...
Open the catalog to page 4ULTRA Anchor User Guide - 8 4.Would it be suitable to use a regular connector for the ULTRA Anchor? Generally speaking, when an anchor is subjected to great force, they drag. Therefore, they do not test the connectors to their total limit. However, due to the incredible holding power of the ULTRA Anchor, you will need to use a connector with a breaking strength no less than that of the connected chain. Therefore, we recommend using the ULTRA FLIP SWIVEL, which has been tested and proved to have higher breaking strength than the chain. 5. How do we recover the anchor if it is hooked the rocks?...
Open the catalog to page 5ULTRA Anchor User Guide -10 ULTRA Anchors heavier than 45 kg cope well among these weeds; however, a good hold might not happen with your first attempt to penetrate the weeds. If you plan to anchor in this ground for extended periods, please be aware that your anchor could work itself loose. Always check the suitability of the ground type before choosing a safe anchorage. 7.How do we anchor on pitched sea beds? 8.What happens if the wind and tide changes direction while at anchor? Unlike other anchors, the ULTRA Anchor keeps holding firm even after 180-degree shifts in both wind and tide. This...
Open the catalog to page 6ULTRA Anchor User Guide - 12 12.Will the ULTRA Anchor align itself onto the bow roller upside down? The ULTRA Anchor or any other anchor can be returned to the bow roller the wrong way up. However, due to the clever design of the ULTRA Anchor with its unique self-aligning characteristics, it will always align itself correctly onto the bow roller. If you find the ULTRA Anchor is upside down when trying to recover it, there could be other causes, for example ; a) A narrow canal on some bow rollers could prevent the ULTRA Anchors' self-righting design from flipping itself into the correct position...
Open the catalog to page 75 Pages
5 Pages
6 Pages