PRODUCT INFORMATION VENTED LOOPS WITH SOLENOID Designed and made in New Zealand, Tru-Design Vented Loops with Solenoid are the superior composite siphon break solutions for marine applications. Vented Loops prevent water siphoning from underwater skin fittings back into a vessel and thereby guard against accidental flooding and sinking. Vented Loops are used predominantly in toilet to overboard applications, toilet inlet applications and holding tank to overboard applications. They can also be used in genset or small engine inlet cooling water systems. A Solenoid controlled Vented Loop allows the vent to be switched to fully closed. This eliminates air entering the system as occurs with a standard vented loop. The solenoid used is normally open, requiring power only to close the valve. Vented Loops are moulded from a glass reinforced nylon composite. High strength, high-modulus glass fibres impregnated into the nylon provides dramatic strength, stiffness, toughness, and dimensional stability to our loops. MODELS Part # Vented Loop w Solenoid 12VDC19mm White Vented Loop w Solenoid 12VDC 25mm White Vented Loop w Solenoid 12VDC 38mm White Vented Loop w Solenoid 24VDC 19mm White Vented Loop w Solenoid 24VDC 25mm White Vented Loop w Solenoid 24VDC 38mm White Doc: PIS - Vented Loop with Solenoid 3.0.doc LEADERS IN MARINE COMPOSITE FITTINGS

PRODUCT INFORMATION KEY FEATURES Feature : Manufactured from a glass reinforced nylon composite High strength and light weight. Robust polymer covered solenoid Long life in the marine environment Diaphragm valve Faster breaking of siphon due to larger flow rate available, Female threaded Solenoid Valve No brass/bronze adapter to corrode Constant internal diameter Self-contained mounting 3 screw mounting posts give secure and easy installation. Chemical resistant Impervious to diesel, petrol and antifouling paints. These fittings will not break down with ultraviolet light or discolour from the...

PRODUCT INFORMATION DIMENSIONS All dimensions in mm. All dimensions nominal. INSTALLATION Full installation instructions are supplied with the Vented Loop with Solenoid. It is recommended that all Vented Loops are placed in a protected location to minimize the chance of inadvertent damage. The Vented Loop should be mounted a minimum of 250mm (1’) above the heeled water line. If mounted below the waterline, the vented loop will not leak, but will not provide any protection. The vented loop should be screwed to a bulkhead or other robust structure using the integral feet. Dual hose clamps should...