Manual Ball Valve
7Pages

PRODUCT INFORMATION BALL VALVE Designed and made in New Zealand for use in marine applications above and below the water line, our Ball Valves are IMCI approved to ISO standard 9093-2, and are ideal for controlling inlet and outlet water requirements. The body of the Ball Valve is manufactured in glass reinforced nylon composite with high impact and tensile strength resulting in a light weight unit, free from corrosion and electrolysis issues. The ball and sealing rings utilise a PTFE polymer to ensure a smooth action, and continuous ease of operation over many years. The Ball Valve is available in both BSP and NPS thread forms and can be locked in the closed position for use on toilet waste outlets. MODELS Internal diameter * PKG denotes product is packaged in a plastic bag with header card. Other product is packaged loose.

PRODUCT INFORMATION KEY FEATURES Large handle for easy operation Brightly coloured handle allows easy viewing of position Able to be locked for compliance with toilet waste outlet standards Size and thread form is marked on each end of the product BSP or NPS thread form Valve position is marked for easy identification Spanner is available for easy and damage free installation Glass reinforced nylon composite construction Light weight and high strength Corrosion resistance o Long life o Minimal maintenance o No corrosion deposits to remove Electrically non conductive o No electrical bonding...

PRODUCT INFORMATION STANDARDS Tru-Design Ball Valves are certified by the International Marine Certification Institute (IMCI) to meet; ISO 9093-2 Small craft -- Seacocks and through-hull fittings -- Part 2: Non-metallic In meeting ISO 9093-2, our Ball Valves have been tested with a 155kg load hanging off a hose fitting while connected to our Skin Fitting as shown. The locking feature allows the Ball Valve to comply with US Coast Guard Regulation 33 CFR 159.7 and ISO Standard 8099 for locking of toilet waste outlets. SPECIFICATIONS The connecting threads on each end of the Ball Valves are a...

PRODUCT INFORMATION DIMENSIONS All dimensions nominal.

PRODUCT INFORMATION

PRODUCT INFORMATION

PRODUCT INFORMATION INSTALLATION If the valve is to be assembled to a skin fitting, ensure that the position of the skin fitting is such that it will be in a protected area, but readily accessible. Ensure threads of mating fittings have a parallel thread and it is clean and undamaged. Apply sealing tape to the thread of the Skin Fitting or Tail. Screw ball valve onto the mating fitting using the correct Ball Valve Spanner (available from Tru-Design), or other appropriate tool. Tighten any attached fittings to a maximum of 16Nm (12ft/lbs). Check that the final position of the Ball Valve is...