Catalogs >
Transfluid >
SL SPRING LOADED BRAKES

SL SPRING LOADED BRAKES
1 / 4Pages

Catalog excerpts

SPRING LOADED BRAKES

SL SPRING LOADED BRAKES To brake high inertia loads, or when operating conditions are particularly severe, we suggest the following formula is used to select the brake: The spring loaded SL brakes are designed for all applications where a fail safe brake is required. The brake consists of an hydraulic assembly, a plate assembly and a driven hub which can be supplied by TRANSFLUID upon request or can be manufactured by Customer. SL brake is a hydro-mechanical device which is Spring Loaded and hydraulically released. A spring load exerts a compressive force between steel plates, which are...

Open the catalog to page 2

For economical quantities Dimensions are subject to alteration without notice SL spring loaded brakes - 2407

Open the catalog to page 3

SL SPRING LOADED BRAKES ASSEMBLY 1 – Fit hub A onto the shaft. 2 – Mount gasket B and gear tooth ring C on the frame of the machine. 3 – Insert the plates as follows: sintered plate D, steel plate E and so on: the complete pack should end with a sintered plate D. 4 – Mount gasket F, hydraulic assembly G, gasket H and end plate K. 5 – Tighten screws L up to a particular locking torque. 6 – Close outlet hole by plug M (supplied by Customer). 7 – Fill with oil the plate group up to the level hole which must then be closed by plug N (supplied by Customer). Close filling hole by plug P (supplied...

Open the catalog to page 4