SERIES B WASTE TANKS VERTICAL RANGE A range of blow moulded tanks, manufactured in Italy from High Density Polyethylene. These tanks are ISO 8099 compliant and come in capacities of 40 and 60 Litres. An inspection hatch with a diameter of 127mm is included as well as a sender mounting plate to accept WEMA standard units. A full range of fittings are available to connect up to your waste system (1 x 3/4 BSP female- vent, 2 x 1 1/2 BSP male with dip pipoutlet, 1 x 1 1/2 BSP female- inlet, 1 x standard 5 hole sender fitting blanking plate supplied as standard). Stock held: Capacity 40 ltrs 60 ltrs Ref. TT-196881 TT-196882 L 400 400 W 250 250 H 540 750 VERTICAL WASTE TANK HORIZONTAL RANGE A range of blow moulded tanks manufactured in Italy from High Density Polyethylene. These tanks are ISO 8099 compliant and come in capacities of 40,60,80 and 100 Litres. The plastic "Loops" in the top of the tank are designed to hold either a macerator or diaphragm pump in position without the need for screws and bolts. An inspection hatch with a diameter of 127mm is included as well as a sender mounting plate to accept WEMA standard units. A full range of fittings are available to connect to your waste system (1 x 3/4 BSP female - vent, 2 x 1 1/2 BSP male with dip pipesoutlets , 6 x 1 1/2 BSP blanked off female- inlets , 1 x standard 5 hole sender fitting - blanking plate supplied as standard, 9 x pump mounting loops). Stock held: Capacity 40 ltrs 60 ltrs 80 ltrs 100 ltrs Ref. TT-196867 TT-196868 TT-196869 TT-196870 L 547 775 1005 1245 W 400 400 400 400 H 270 270 270 270 HORIZONTAL WASTE TANK TEK TANKS The Old Stables,West End Farm, Upper Froyle, Alton, Hampshire GU34 4JR. England Tel: +44 (0)1420 520830 fax: +44 (0)1420 520840 email: [email protected] www.tek-tanks.com Reg. Office: Cowdown Business Park, Micheldever,Winchester, Hampshire, SO21 3DN. England. Registered in England No. 3857992 VAT Registration No: 744 9594 83 a member of the