Fly-By-Wire Steering Engine and Rudder control Throttle and shift control for single and twin screw vessels. Suitable for mechanical and electronic engines and gear boxes. Up to eight stations possible. Super soft Shifting Clutch engagement is always gentle, with no rocking. Clutch pressure is increased steadily, when a Trolling Valve is installed. Several functions are available as an option: Trolling Mode, Remote Engine Start, Starter Lock out, Synchronizer, Speed Control, Joystick, Virtual Anchor Mode and Hover Mode. AIS MOB Mode The Vessel automatically returns to a crew member’s personal AIS MOB beacon and stops in front of the MOB. The person can then swim to the boat and climb on board. Joystick Forget complicated shift, throttle and steering wheel combinations in close-quarter maneuvering. Simply move or twist the Joystick into the direction you want your boat to move. Much easier than the traditional way. Hover Mode and Anchor Mode By pressing a button, the present Satellite-Position is held automatically. A desired relative wind angle or a heading may be selected while hovering. A perfect feature for waiting at the fuel dock or for a bridge or lock to open. Slow Mode When maneuvering at low speed, the proIn Anchor Mode the boat is pulsion and steering tied to a virtual buoy. Buoy posystem automatically - or sition may be adjusted with the manually - switches into Joystick. On single screw Slow Mode. Steerable boats a bow thruster may be Stern or Pod or Jet Drives needed. will then be controlled individually, available Thrusters and Trolling Valves will be used automatically. CAN-Bus length up to 700 ft (200 m) Even without Thrusters you get massive maneuvering power from individually steered Drives to master a side wind or current and move in any diFADECrection. Box remote FBWRudder, Throttle and Thruster control fixed FBW- JoyDriveAPThe Fly-By-Wire Steering Wheel makes steering station Station Box Display stick easier than driving a car. Turns are gyro stabilized. Avoiding actions become easy. Putting the wheel in its center detent will draw a straight line on your plotRudder-Drive ter. By deflecting the Throttle and Shift Actuawheel, the desired turn tor (or Thrust Reverser on Bow or Stern rate is selected. TogWater Jet Drives) Thruster gle switches are used for individual Thruster Throttle or shift actuacontrol and for Speed tor for mechanically selection. operated engines. Torque 200 ins.lbs. Remote control on a 20 ft. Speed Mode (22 Nm), pulling force Desired Ground (6 m) spiral cord 90 lbs. @ 3 in. travel Speed can be select(400 N @ 80 mm), ed in Speed Mode with the Joystick or with toggles, weight 4 lbs/1.7kg similar to common Speed control on the road. www.tecnautic.com TECNAUTIC 22120 Parthenia Street West Hills (Los Angeles), CA 91304 Tel (888) 841-8851 Fax (818) 337-7582 e-mail: [email protected] TECNAUTIC GmbH Kasernenstrasse 4 b CH-8184 Bachenbulach Tel+41-44-8862986 Fax+41-44-8862988 [email protected]