BREY-KRAUSE MANUFACTURING STAINLESS STEEL (5) STEP DOCK LADDER FIXED FRONT MOUNT Brey-Krause Mfg. reserves the right to make changes in design and/or materials without formal notice and without incurring obligation. WELDED 18 4 "q DEEP UPPER RAIL MOUNTING 3 NON-SLIP SURFACE TECHNICAL DATA SHEET L-1222-LB 1209 W. LEHIGH ST., BETHLEHEM, PA 18018 PHONE: 610-867-1401 FAX: 610-866-1433 www.breykrause.com DESCRIPTION UPPER RAIL ASSEMBLY 5 STEP LOWER ASSEMBLY SS WASHER, 0.390 X 5/8" SS 3/8-16 X 2 SHCS SS 3/8-16 NYLOC NUT LOWER MOUNTING FLANGES INSTALLATION: 1. Install the (2) upper rail assemblies square to the top surface of the dock using the 5 3 14 32 " dimension from the front dock mounting surface, rail to rail 25 16 " apart to the outside of the flanges. 2. Slide the lower ladder fully into the upper rails and install the bolts. Use a scrap 1 piece of wood (2x4) cut to 23 4 " to support the upper rails while you mount the lower ladder. 3. Slide the slip support flanges onto the lower ladder mounting posts, short end up. 1 Use the 3 4 " dimension as a reference to maintain the ladder plumb.Check the ladder with a level and mount them to the front face of the dock. Check that all bolts are tight. (Note the mounting dimensions on the drawing) Operation: Only one person at a time should use the ladder. The ladder is not to be used as a mooring point for boats or personal watercraft. The mounting bolts used to secure the ladder flanges should be inspected periodically for tightness. Assembled Ladder Weight: 42 Lbs.