TC 8000
1Pages

Catalog excerpts

Monitor and Control up to 8 tanks from one location The TC-8000 Controller provides an intelligent networked solution for the monitoring and control of up to eight tanks. The diagram (right) shows a typical system layout. The system consists of the TC-8000 display controller (as seen above) up to eight HT-100 or HT-100/P tank controllers and any number of optional RD-800 repeater displays communicating via a 2-wire network cable with a maximum cable length of 1000 meters. TC- 8000 DISPLAY CONTROLLER: Is a powerful tank monitor and control system. • Full control from one central location on your boat. • Visual indication of tank level, seacock position & pump status. • Turn holding tank macerator pump on/off manually or automatically. • Turn water maker on/off manually or automatically. • Visual & audible tank full and fault alarms. • Three modes of operation: manual, auto grey or auto all. • Mode change is key switch selectable. • Displays in Litres or Gallons and Percentage. •Three display modes available (see right). • All tanks are name programmable giving tank location and type, e.g. Aft Port, Grey Tank. HT-100 or HT-100/P: Is a controller which manages the tank pump, the electric seacock, tank high output and provides an input for the fluid level sensor. • Teach-in for level sensor with four point interpolation for irregular shaped tanks. • Controls the pump, the electric seacock (if fitted) and provides the input for the level sensor. • Reversed output for tanks programmed as either fresh water or fuel, enabling water maker or fuel transfer pumps to turn on when empty and off when full. • Tank high level output which can be connected to the Aus/Sea toilet controller which disables the toilet when the holding tank is full. • Interface to electric seacock, or standard seacock interlock switch. • Internal pump on/off override switch for tank servicing and cleaning. - HT-100/P features level sensor, tank high output, pump & electric seacock control. - HT-100 features level sensor and tank high output. RD-800: Repeater Display (optional extra). Connect any number of these to allow convenient tank monitoring from anywhere on the vessel. EIGHT CHANNEL HOLDING TANK CONTROLLER SYSTEM LAYOUT FOR MODEL TC-8000 Any device can sit anywhere on this two core Bus cable. Any combination of HT-100/P and or HT-100 (up to eight) can be connected plus, any number of repeater displays (model RD-800). NOTE: The HT-100/P has the pump and valve option while the HT-100 does not. ELECTRIC VALVE WITH INTERLOCK ELECTRIC VALVE WITH INTERLOCK ELECTRIC VALVE WITH INTERLOCK ELECTRIC VALVE WITH INTERLOCK TANK FULL DISABLE TANK FULL DISABLE TANK FULL DISABLE TANK FULL DISABLE 2 CORE CABLE. MAX LENGTH 1000 METRES TANK FULL TANK FULL TANK FULL TANK FULL Supply Voltage: 12-32 Volts DC (Auto sensing) | Quiescent Current: 5 Milliamps (without backlight) Backlight | Reverse polarity protected | Network cable length=1000m | Voltage & EMI Protected Data Retention: 50 years (without power)

Open the catalog to page 1

TC 8000
1Pages

Catalog excerpts

All Smart Switch Technologies catalogs and brochures

Archived catalogs

TC 8000 1Pages

Catalog excerpts

All Smart Switch Technologies catalogs and brochures

Archived catalogs

TC 8000
1Pages