Part No: FC - 8000 Actual Size = 126 x 116 x 21mm Fuel Tank Controll THE FC - 8000 EIGHT CHANNEL HOLDING TANK CONTROLLER SYSTEM LAYOUT FOR MODEL FC-8000 Any combination of FT-100, HB-200 or HB-200/P (up to eight) can be connected plus, any number of repeater displays (model RF-800). Eight Channel Fuel Tank Controller System Layout for Model FC-8000. Monitor and Control up to 8 tanks from one location. Transfer screen The FC-8000 Controller provides an intelligent networked solution for the monitoring and transferring fuel from or to (up to) eight tanks. The diagram (right) shows a typical system layout. The system consists of the FC-8000 display controller (as seen above) up to eight FC-100 tank controllers and any number of optional RF-800 repeater displays communicating via a 2-wire network cable with a maximum cable length of 1000 meters. 280 Lts 700 Lts Note: The system can monitor and control up to eight tanks. The eight tanks can be any combination of fuel, fresh, grey or black. Any FT-100 controller or controller’s may be replace with either a HB-200 or HB-200/P if Any device can sit anywhere on this two core Bus cable. either a fresh, grey or black tank or tanks would like to be monitored instead of fuel. Only fuel may be transferred. Model RF - 800 Up to three remote displays may be tted FC- 8000 DISPLAY CONTROLLER: Is a powerful tank monitor and control system. • Full control from one central location on your boat. • Transfer from any tank to any tank. Model FC - 8000 Tank Controller FT - 100 Tank Controller FT - 100 • Control either AC or DC or both transfer pumps Tank Controller FT - 100 • Visual indication of tank level Solenoid Valve Bottom • Visual & audible tank full and fault alarms. Solenoid Valve Bottom Solenoid Valve Top • Displays in Litres or Gallons and Percentage. Solenoid Valve Bottom Solenoid Valve Top Solenoid Valve Top DC Pump Controller DC- P100 • All tanks are name programmable giving tank location and type, e.g. Aft Port, Grey Tank. Blue = 2 Core Data Cable RF-800 REMOTE DISPLAY UNIT: The RF-800 Repeater Display is an optional extra.RF-800 is for monitoring only and will not allow control. Up to three units may be connected throughout the vessel for convenient tank monitoring. Note: The FT-100 FUEL CONTROLLER: This controller is used to manager the fuel tanks Solenoid valve’s (top & bottom) the safty top switch and provides an input for the uid level sensor. AC Pump Controller AC - P200 Battery Tank Controller FT - 100 Tank Controller FT - 100 Tank Sensor Solenoid Valve Bottom HB-200 CONTROLLER: Solenoid Valve Top Tank Controller FT - 100 Tank Sensor Solenoid Valve Bottom Solenoid Valve Top Tank Sensor Solenoid Valve Bottom Solenoid Valve Top Tank Controller FT - 100 Tank Controller FT - 100 Tank Sensor Solenoid Valve Bottom Solenoid Valve Top This controller is used for other tanks eg. Grey or Black and provides an input for the uid level sensor and a pump output. Pump Tank Sensor Solenoid Valve Bottom Solenoid Valve Top This controller is used for other tanks eg. Fresh, Grey or Black and provides an input for the uid level sensor. HB-200/P CONTROLLER: Pump Supply Voltage: 12 ~ 32 Volts DC (Auto sensing) | Quiescent Current: 12 Milliamps (with backlight off) Backlight Reverse polarity protected | Network cable length=1000m | Voltage & EMI Protected AC Supply