BC-8000
1Pages

8 Channel Bilge Controller BC 8000 Actual Size = 126 x 116 x 21mm 8 Channel Bilge controller BC 8000 SYSTEM OVERVIEW The BC-8000 Bilge Controller has been developed for intelligent intervention and controlling pumps in up to 8 bilge areas. Monitor/Control up to 8 bilges from one location. The BC-8000 Controller provides an intelligent networked solution for the monitoring and control of up to eight bilge areas. The diagram (right) shows a typical system layout. The system consists of the BC-8000 display controller (as seen above) up to eight BC-100 or BC-100/P controllers and one (optional) RB-800 repeater displays. The system communicates via a 2-wire network cable with a maximum cable length of 1000 meters. BC- 8000 DISPLAY CONTROLLER: Is a powerful bilge control system. • Full control from one central location on your boat. • Delay pump on and off time (programmable). • Pump on alarm time (programmable). • Visual status display for each bilge area showing pump status, low sensor status, last pump run time, number of pump runs, program & operate modes. • Turn bilge pumps on/off manually or automatically • Visual & audible alarm for any fault conditions eg, high water, low sensor fault, pump fault, time alarm. • Two master modes of operation automatic or semi-automatic. • Individual modes auto or manual. • All bilge areas are name programmable giving location e.g. (Aft Port) (Engine Room) (Mid Ship Starboard). BC-100 or BC-100/P I/O UNIT: Are controllers which manage the pump, relay, and high/low sensors. • Automatically goes into stand alone mode if communication with the BC-8000 is lost giving normal operation if either the hi or low sensors turn on. • Controls the pump and provides the input for the hi & low sensors. • Pump output = 88 amps @ 12 vdc. • Operates with any standard float switch or Smartswitch FS-2A. • Alarm relay = 3 amp inductive. It is a network system consisting of the BC-8000 Master Display Unit and up to eight I/O Units located in bilge compartments. In addition as an option, the RB-800 Remote Display Unit may be added to provide remote bilge status anywhere on the vessel. Builders and retrofitters can now offer reasonably priced systems, while providing boat owners with outstanding visibility into conditions in their bilge areas, allowing a variety of control options under both normal and off-normal conditions. 2 WIRE NETWORK (STANDARD TELEPHONE WIRE) BC 100/P LOCAL BILGE AREA PUMP CONTROL BC 100 LOCAL BILGE AREA MONITOR BC 8000 MDU BILGE ALARM PUMP OUTPUT ALARM OUTPUT EIGHT-CHANNEL BILGE CONTROLLER BILGE CONTROL MODULE (NO PUMP OUT) BILGE CONTROL MODULE (PUMP OUT) NETWORK INTERFACE MODULE PRODUCT DESCRIPTION: WATER SENSOR ORDER INFORMATION PART NUMBER: Supply Voltage: 12 ~ 32 Volts DC (Auto sensing) | Quiescent Current: 26 Milliamps (with backlight off) | Backlight Reverse polarity protected | Network cable length=1000m | Voltage & EMI Protected Programmed Data Retention: 50 years (without power) These features are unique to the BC-8000. They provide maximum flexibility to locate components on-board the vessel while minimising wiring costs. All devices are interconnected by a 2-wire network cable similar to that used for telephone installations. • Supplied in two different models: - HT-100/P features hi & low sensors, alarm relay, and pump output - HT-100 features hi & low sensors and alarm relay RD 800: This Remote Display is an optional extra and may be connected anywhere on the vessel for convenient monitoring. The Master Display Unit (MDU) controls communication with all attached I/O Units and provides monitoring of all bilge areas from a central location. System components may be located anywhere on the network cable and the cable may be up to 1000 meters in length. REMOTE DISPLAY *SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.