Catalogs >
Sigma Coatings PPG PMC >
SIGMASHIELD 1090

SIGMASHIELD 1090
5Pages

Catalog excerpts

SIGMASHIELD 1090 (SigmaCover Armour Compound) 5 pages November 2012 Revision of February 2010 two component ultra high build int reinforced solvent free polyamine cured, epoxy compound PRINCIPAL CHARACTERISTICS – – – – – – – – seamless water impermeable layer with excellent anticorrosive properties suitable for the protection of steel and concrete excellent resistance against impact and wear excellent adhesion under dry and wet exposure conditions resistant to water and splash of mild chemicals can be exposed to water within 30 minutes after application texture of surface is rough suitable for decks exposed to heavy impact and abrasion white (other colours on request) – at (1 g/cm³ = 8.35 lb/US gal; 1 m²/l = 40.7 ft²/US gal) (data for mixed product) Mass density Volume solids VOC (Directive 1999/13/EC, SED) VOC (UK PG 6/23(92) appendix 3) Recommended dry lm thickness Theoretical spreading rate Touch dry after Overcoating interval Full cure after 2.0 g/cm³ 100% max. 35 g/kg (Directive 1999/13/EC, SED) max. 68 g/l (approx. 0.6 lb/gal) *See information sheet 1411 3 - 5 mm 0.2 m²/l for 5000 μm (=approx.10kg/m²) 0.3 m²/l for 3000 μm (=approx.6 kg/m²) 6 - 8 hours at 20 °C min. 4 days * max. 30 days * 7 days * at 20 °C (data for components) Shelf life (cool and dry place) at least 6 months * see additional data RECOMMENDED SUBSTRATE CONDITIONS AND TEMPERATURES steel; blast cleaned to ISO-Sa2½, blasting prole 75 - 100 μm concrete; free from laitance by blast cleaning moisture content of concrete should be max. 4% substrate temperature should be above 5°C and at least 3°C above dew point

Open the catalog to page 1

(SigmaCover Armour Compound) November 2012 mixing ratio by volume: base to hardener 90.4 : 9.6 Induction time Pot life – not prepare more material than can be used within 30 minutes – the temperature of the mixed base and hardener when mixing the components should be approx. 20°C – use always mechanical mixing equipment – add the hardener while stirring the base – mix thoroughly and quickly until a homogeneous material is obtained none 30 minutes at 20 °C * *see additional data CLEANING SOLVENT Thinner 90-83 (preferred) or Thinner 90-53 – all application equipment must be cleaned...

Open the catalog to page 2

(SigmaCover Armour Compound) November 2012 Pot life (at application viscosity) 20 °C 30 °C – A sprayable polymer mortar is a heavy material which has to be transported from the container with mixed material to the mortar spray gun or airless spray gun. – So preferably 3/4 - 1 inch hoses should be used (for the airless spraying, just before the spraygun 5/8 inch). – Care should be taken that hoses are of sufciently large diameter, are as short as possible and that no obstructions are present; otherwise the binder will be pressed out of the mortar leaving dry (untransportable) material...

Open the catalog to page 3

(SigmaCover Armour Compound) November 2012 Worldwide availability Whilst it is always the aim of Sigma Coatings to supply the same product on a worldwide basis, slight modication of the product is sometimes necessary to comply with local or national rules/circumstances. Under these circumstances an alternative product data sheet is used. Conversion tabels Explanation to product data sheets Safety indications Safety in conned spaces and health safety Explosion hazard - toxic hazard Safe working in conned spaces Directives for ventilation practice Cleaning of steel and removal of rust...

Open the catalog to page 4

(SigmaCover Armour Compound) November 2012 WARRANTY PPG warrants (i) its title to the product, (ii) that the quality of the product conforms to PPG’s specications for such product in effect at the time of manufacture and (iii) that the product shall be delivered free of the rightful claim of any third person for infringement of any U.S. patent covering the product. THESE ARE THE ONLY WARRANTIES THAT PPG MAKES AND ALL OTHER EXPRESS OR IMPLIED WARRANTIES, UNDER STATUTE OR ARISING OTHERWISE IN LAW, FROM A COURSE OF DEALING OR USAGE OF TRADE, INCLUDING WITHOUT LIMITATION, ANY OTHER WARRANTY OF...

Open the catalog to page 5

SIGMASHIELD 1090 5Pages

Catalog excerpts

All Sigma Coatings PPG PMC catalogs and brochures

SIGMASHIELD 1090
5Pages