Mass density Volume solids Recommended dry film thickness Theoretical spreading rate Overcoating interval Full cure after Shelf life (cool and dry place) One pack urethane polyester finish coat for on board maintenance - easy to apply on topsides, decks and superstructures - easy application by brush and roller - excellent flow and levelling properties - quick drying - good adhesion on most aged, sound alkyd-, epoxy- and polyurethane - high gloss - good colour and gloss retention white and various other colours (see also the SigmaCare Shade Card of PPG Protective & Marine Coatings) - gloss - previous coat; (alkyd, epoxy or polyurethane) dry and free from any contamination and sufficiently roughened if necessary - substrate temperature should be at least 3°C above dew point but not above systems for superstructure and deck fitting stir well before use the temperature of the paint should preferably be above 15°C adequate ventilation must be maintained during application and curing (please referto sheets 1433 and 1434) Recommended thinner Marine Coatings

for paint and recommended thinners see safety sheets 1430,1431 and relevant material safety data sheets this is a solvent borne paint and care should be taken to avoid inhalation of spray mist or vapour as well as contact between the wet paint and exposed skin minimum 20 hours 14 hours 8 hours 6 hours 5 hours - surface should be dry and free from any contamination Whilst it is always the aim of PPG Protective & Marine Coatings to supply the same product on a worldwide basis, slight modification of the product is sometimes necessary to comply with local or national rules/circumstances. Under these...

SIGMADUR ONE January 2011 LIMITATION OF LIABILITY The information in this data sheet is based upon laboratory tests we believe to be accurate and is intended for guidance only. All recommendations or suggestions relating to the use of the Sigma Coatings products made by PPG Protective & Marine Coatings, whether in technical documentation, or in response to a specic enquiry, or otherwise, are based on data which to the best of our knowledge are reliable. The products and information are designed for users having the requisite knowledge and industrial skills and it is the end-user's responsibility...