SEAGUARD VOID COAT Protective & Marine Coatings WATER BASED BARGE COATING P31A10 Revised 3/11 PRODUCT DESCRIPTION RECOMMENDED USES • Excellent corrosion protection • HAPS free • High lm build capability • Resistant to high temperatures • Suitable for severe atmospheric corrosion protection • Little or no pretreatment required • Resistant to high pressure steam cleaning • SEAGUARD VOID COAT is a premium grade, single component, water based coating containing no HAPS and very low VOC. The coating is intended to be applied to the interior spaces of fresh and salt water barges. This product contains high PIN (penetration index) asphalt to provide enhanced lm exibility. The product was formulated with the intent to protect the steel plate from corrosion with little or no surface preparation. Loose mil scale should be removed; tightly adhering mil scale does not require removal and will provide a suitable substrate. This product is easily applied via airless spray and is intended to be applied at a wide range of application temperatures and conditions. Effective in Salt Water Barges PERFORMANCE CHARACTERISTICS PRODUCT CHARACTERISTICS Finish: Semi-Gloss Color: Gray Test Name Volume Solids: 56% Weight Solids: 63% VOC (less water): 0.1 lb/gal Theoretical Coverage @ 5 mils dry: 179 sq. feet per gallon (100% transfer efciency) Recommended Spreading Rate per coat: Dry mils: Minimum 3.0 Corrosion Resistance Direct Impact Resistance High Temperature Resistance Reverse Impact Resistance Salt Water Immersion Test Method Results ASTM B117 Passes (336 hours) ASTM D2794 160 in. lbs. Dry lm will not ow <450°F ASTM D2794 20 in. lbs. ASTM D870-97 Passes (336 hours) Maximum 9.0 Drying Schedule @ 10.0 mils wet @ 50% RH: @ 77°F To touch: To cure: 2 hours 24 hours Drying time is temperature, humidity, and lm thickness dependent. Shelf Life: 12 months Flast Point: >200°F Setaash Reducer/Clean up: No reduction required Clean up with water www.sherwin-williams.com/protective continued on back

SEAGUARD VOID COAT Protective & Marine Coatings WATER BASED BARGE COATING P31A10 PRODUCT INFORMATION SURFACE PREPARATION RECOMMENDED SYSTEMS Dry Film Thickness / ct. Mils Steel, alkyd primer: 1 ct. Seaguard Void Coat 3.0-9.0 (Airless spray application is recommended using 30:1 ratio or greater with .017 - .037 tip.) Surface must be clean, dry, and in sound condition. Remove all oil, dust, grease, dirt, loose rust, and other foreign material to ensure adequate adhesion. This product is thixotropic similar to ketchup, mixing may be required to provide optimum ow characteristics. If the product...