SEAGUARD VOID COAT LT Protective & Marine Coatings WATER BASED BARGE COATING LOW TEMPERATURE VERSION P31A15 Revised 11/10 PRODUCT DESCRIPTION RECOMMENDED USES SEAGUARD VOID COAT LT is a premium grade, single component, water based coating containing no HAPS and very low VOC. This coating is a modied version of the Seaguard Void Coat. The coating has been modied for application in low temperature conditions. This coating is intended for application to buoyancy and bilge tanks in fresh and salt water barges/vessels. Because the coating contains antibacterial components it should not be used to line tanks that will be utilized for potable water. PRODUCT CHARACTERISTICS Finish: Semi-Gloss Color: Gray Volume Solids: 0.5 lb/gal Can be applied in cold winter temperatures Extreme corrosion protection HAPS free High lm build capability Suitable for severe atmospheric corrosion protection Little or no pretreatment required Resistant to high pressure steam cleaning Effective in Fresh and Salt Water Barges/Vessels 72% VOC (less water): Highly resistant to tobacco juicing 65% Weight Solids: • • • • • • • • • • PERFORMANCE CHARACTERISTICS Test Name Theoretical Coverage @ 5 mils dry: 208 sq. feet per gallon (100% transfer efciency) Drying Schedule @ 10.0 mils wet @ 50% RH: @ 20°F To touch: To cure: Well ltered before packaging with the consequence that an entire barge can be coated without once stopping to unclog the spray tip 2 hours 24 hours Drying time is temperature, humidity, and lm thickness dependent. Shelf Life: 12 months Flast Point: 110°F Reducer/Clean up: Corrosion Resistance Direct Impact Resistance High Temperature Resistance Reverse Impact Resistance Salt Water Immersion No reduction required Clean up with water Tobacco Juicing www.sherwin-williams.com/protective Test Method Results ASTM B117 Passes (336 hours) ASTM D2794 160 in. lbs. Dry lm will not ow <450°F ASTM D2794 20 in. lbs. ASTM D870-97 Passes (336 hours) Staining of lm applied to wet steel in 95% humidity Pass continued on back

SEAGUARD VOID COAT LT Protective & Marine Coatings WATER BASED BARGE COATING LOW TEMPERATURE VERSION P31A15 PRODUCT INFORMATION SURFACE PREPARATION RECOMMENDED SYSTEMS Dry Film Thickness / ct. Mils Steel, alkyd primer: 1 ct. Seaguard Void Coat LT 5.0-10.0 (Airless spray application is recommended using 30:1 ratio or greater with .017 - .037 tip.) Surface must be clean, dry, and in sound condition. Remove all oil, dust, grease, dirt, loose rust, and other foreign material to ensure adequate adhesion. This product is thixotropic similar to ketchup, mixing may be required to provide optimum ow characteristics....