CONCRETE BREAKWATER TYPE SFBW1000/3,0 The geometry of this pontoons, in combination with our patented coupling and an advanced ancoring system, makes our floating breakwater an excellent wave attenuator. As a result of the use of high quality materials, coupled with a thorough manufacturing process, the pontoon enjoys a long life-span. Each standard pontoon is designed to accept electrical and water supply services. This pontoon has been developed gradually over the years. The first floating breawater was three meter wide and now the breakwaters reaches the width of ten meters which is the largest floating breakwater on the market. Normally, the pontoons would be anchored using chains and blocks. Ancoring on piles is also possible. The breakwaters from SF MARINA are concrete pontoons with all the advantages of high stability and buoyancy. The concrete and eps construction of the pontoon produces a very high degree of buoyancy thus making it virtually unsinkable. The pontoons are first and foremost used as a floating breakwater. However, they can be used universally where the potential of a pontoon having high stability can be utilized. S P E C I F I C AT I O N S The pontoon is manufactured in accordance with the Eurocode SS-EN1992-1-1 Length: Width: Width: Height: Weight: Freeboard: Connectors: Breaking load: 20.00 m. Incl. fender 10.25 m. Excl. fender 10.00 m. 3.0 m. Approx. 200 ton. Approx. 0.8m 2 units type W 5000 per joint. W 5000: 2 x 260 ton per joint. Concrete pontoons: Concrete: C40/50. Air 6%. Wct< 0.4. Reinforcement: Nps 500, K500 C-T. EPS: min. 80kPa. Cast-in materials: Stainless and hot-dipped galvanised steel. Wood fender: Pressure-treated pine 95 x 145 mm. Other dimensions can be offered upon request. Rights reserved for alterations www.sfmarina.com [email protected]