Single spreaders. Double spreaders. Seldén T-spreaders for C-sections and F-sections. Triple spreaders.

The C-section’s and F-section’s spreader fitting is a through-mast design which provides strength as well as a smooth and elegant appearance. The shroud fittings for the lower or middle shrouds are integrated into the spreader attachment. This reduces the number of fittings on the mast, and keeps weight down.

Spreader ends Intermediate shroud (D2) The design of the spreader ends varies with rig type, the number of spreaders, and whether the lateral rigging is linked or continuous. Clamping end plug for continuous rigging. Clamping end plug for V-spreader. V3 Spreader end for linked lateral rigging on 30-70 ft yachts Spreader end plug for linked rigging (from 2008). – inimal distance from shroud to edge of M spreader end. Makes for improved jib trim. Jib can be sheeted close to shroud. – arge, smooth surface. Gentle on the sail. No L tape required. – o split pins to catch sails or halyards. N – orks...

How to order new spreaders The easiest way to order new spreaders for your mast is to provide one of our dealers with the mast ID-number engraved in to the lower end of the mast section. If this ID-number is inaccessible, the following procedure will do. • What mast section is it for? Measure the mast longitudinal and athwartships (mm) and compare with sections listed at page 10. For masts produced earlier than 2002 (E, D, R and P sections), see Version 6 of our catalogue, www.seldenmast.com. What spreader fitting? You will find a part number on the fitting. What length? Measure the length of...

Spreader brackets and spreader assemblies Mast section Bracket pair starboard and port Spreader Assebly Art. No. (1 pair) incl. Clevispins, excl. End plugs

Mast section Bracket pair starboard and port Spreader Assebly Art. No. (1 pair) incl. Clevispins, excl. End plugs * Compression bar to be used only if diagonal shroud is attached via fitting in mast wall (as opposed to attachment in spreader bracket). -01 = With cut-out for stemball -02 = Without cut-out for stemball -11 = T-spreaders for F-sectio

Spreader end plugs, linked rig Interm. shroud Linked end plug (prior to 2008). Interm. shroud Rigging screw dimension Art. No. Prior to 2008 Wire Spridardub dia., mm Linked end plug for stemball terminals (from 2008). Linked end plug for stemball terminals Fork ø10: Drill ø12,5 mm hole Fork ø10: Drill ø12,5 mm hole

Stemball terminals for spreader brackets Stemball terminals The lower shrouds and intermediate shrouds hanging in the spreader brackets have a stemball terminal at the upper end. This terminal is located in the cup of the spreader bracket. If required, it can be used with one or two separate cups to bring it up to the correct size for the cup. Measure the width of the complete assembly, including any cups, to ensure that all the cups are in position. T Mast section Spreader Total width of width, stemball incl. mm any cups, mm T = Terminal (Stemball) T+C=Terminal + Cup T+C+C=Terminal + 2 Cups...