Catalogs >
Seldén Mast AB >
Seldén CXe45

Seldén CXe45
7Pages

Catalog excerpts

ELECTRIC CODE 0 FURLING SYSTEM Watch video

Relax and enjoy the power of Code 0 sailing - Effortlessly (Through Deck) ELECTRIC CODE 0 FURLING SYSTEM Having a furling Code 0 sail set on the bowsprit will deliver the joy that powerful and efficient sailing provides. Combined with a furling jib you will have the ultimate headsail wardrobe from broad reaching to beating upwind, all without leaving the cockpit. The addition of push button convenience guarantees an effortless sailing experience.

Open the catalog to page 2

“The CXe 45 is exceptionally easy to handle, partly because of the high speed when furling the sail. It takes effortless sail handling in light air to a whole new level.“ Magnus Rassy, CEO and owner of Hallberg-Rassy Varvs AB

Open the catalog to page 3

On Deck or Through Deck CXe can be integrated into the bow or bowsprit with a through-deck installation. This permanent installation is always available, ready for the furled sail to be connected. Like other electric functions from Seldén, CXe runs on SEL-Bus and a Power Supply Unit (PSU) converting 12V or 24V to 42V. SEL-Bus is a can-bus system with software that combines intelligence and power on board to sense and adapt loads for maximum efficiency and safety. Once you have installed SEL-Bus you can connect additional functions and run them all on the same PSU. 42V allows for smaller...

Open the catalog to page 4

Accessories Stainless protection bar for TD Code 0 halyard with 2:1 purchase To boost the performance when using a Code 0, the halyard load must be higher than what normal halyard boxes and stoppers can handle. Therefore, a 2:1 purchase needs to be arranged by fixing the dead end of the halyard in the mast and letting it run through a block attached to the halyard swivel. Position on the mast must be specified by Seldén. In most cases Code 0 sails need to be hoisted lower than gennakers and spinnakers. Halyard lead or halyard box Halyard swivel Block for 2:1 purchase Model Safe working...

Open the catalog to page 5

Mast section Thimbles for AT-cable Model SEL-Bus Cable clamps Power Supply Unit. Converts 12V or 24V to 42V To fit thimbles to the Seldén AT-cable. Heat shrink tubing included. Model Parts included Power Supply Unit (PSU), main switch/fuse, SEL-Bus cables and terminals, power cables Parts included Control pack for CXe25 and CXe45 Motor Control Unit (MCU), push buttons, SEL-Bus cables and terminals Double clamps at each end of the cable are required. Learn about SEL-Bus: www.seldenmast.com/products/electric-installations/

Open the catalog to page 6

DINGHIESKEELBOATSYACHTS Seldén Mast AB, Sweden Tel +46 (0)31 69 69 00 e-mail info@seldenmast.com The Seldén Group is the world’s leading manufacturer Seldén Mast Limited, UK Tel +44 (0)1329 50 40 00 e-mail info@seldenmast.co.uk for dinghies, keelboats and yachts. Seldén Mast Inc., USA Tel +1 843-760-6278 e-mail info@seldenus.com Our well known brands are Seldén and Furlex. Seldén Mast A/S, Denmark Tel +45 39 18 44 00 e-mail info@seldenmast.dk build a network of over 750 authorised dealers covering Seldén Mid Europe B.V., Netherlands Tel +31 (0)111-698 120 e-mail info@seldenmast.nl Seldén...

Open the catalog to page 7