SEAJET SEOSIL CLEAR COAT Product description SEAJET SEOSIL CLEAR COAT is a biocide-free, silicone foul-release coating for use on underwater hulls. Provides long term protection against fouling in both fresh and salt water environments. Fouling may loosely attach but is easily removed by water movement or washing (sponge). Product data Colour Flash point Volume solids % Pack sizes Mixing ratio Application details Thinner Application methods Brush, roller*, spray. Ambient temperature Product temperature Substrate temperature Paint output pressure: Spray details Spreading rate Recommended film thickness Wet (µm) 100 per coat Dry (µm) 94 Substrates For use over suitably primed GRP, wood, steel, aluminium, etc. Preceding coating SEAJET SEOSIL TIE COAT Subsequent coating SEAJET SEOSIL CLEAR COAT Before use, stir thoroughly until product is mixed to a uniform consistency. Warning: Due to the presence of silicon compounds, contamination of other areas by e.g. overspray should be avoided. This can result in failure in those areas. Brushes, rollers and spray lines should be dedicated or be thrown away. Mask areas close by to avoid overspray. For the expectations of performance from this foul-release coating in static conditions: It is necessary to consider parameters such as trading pattern and the environmental conditions i.e., traditional level of fouling activity, pollution levels and water temperatures at static locations. In case of brush or roller application, more layers will be required to achieve the specified film thickness. Values are based on roller application. * Suggested roller: Coat X CX4 or CX8. Surface preparation Surface preparation new application: Apply 2 coats of SEAJET SEOSIL CLEAR COAT (using a thick mohair roller) over freshly applied SEAJET SEOSIL TIE COAT. Min. DFT 150 micron, max. DFT 200 micron. Re-coat of SEAJET SEOSIL CLEAR COAT in good condition: Clean the existing surface with low pressure fresh water. Use a soft sponge to remove any fouling which is more difficult to remove. After cleaning rinse the hull with fresh water and let it dry. When the surface is dry apply two fresh coats of SEAJET SEOSIL CLEAR COAT using a thick mohair roller. Min. DFT 150 micron, max. DFT 200 micron. Re-coat of SEAJET SEOSIL CLEAR COAT in bad condition: Clean the existing surface with low pressure fresh water. Use a soft sponge to remove any fouling which is more difficult to remove. Repair the damaged areas by using a paint scraper to remove the existing SEAJET SEOSIL CLEAR COAT. Use abrasive paper (P-100) to roughen the SEAJET SEOSIL TIE COAT. Apply a fresh coat of SEAJET SEOSIL TIE COAT. After repair rinse the hull with fresh water and let it dry. When the surface is dry apply two fresh coats of SEAJET SEOSIL CLEAR COAT using a mohair roller. Min. DFT 150 micron, max. DFT 200

SEAJET SEOSIL CLEAR COAT Drying / overcoating data Notes: Drying times and overcoating intervals will increase with increasing film thickness applied. Before re-coating, always check that the existing paint film is 'through' dry. Store the containers in a dry, cool and well ventilated space and away from direct sunlight. Containers must be kept firmly closed. Handle with care. The product should stay in a securely closed container during transport. Shelf life Do not empty into drains, dispose of this material and its container at hazardous or special waste collection point. Additional information...