SEAJET 039 PLATINUM 2-COMPONENTS Product description Seajet 039 Platinum is an advanced Self Polishing Copolymer (SPC) antifouling. An ultimate performance antifouling suitable for the highest fouling areas. Ideal for blue water cruisers. Can be used on all substrates except aluminium. Product data Colour Flash point Volume solids % VOC (Theoratical) Pack sizes Mixing ratio Mid blue, navy blue, red, black 27°C 48 ±2 Application details Thinner Application methods Conditions SEAJET THINNER A Brush, roller, spray (professional use only)* Spray details Spreading rate Recommended film thickness per coat Substrates Preceding coating Subsequent coating Ambient temperature Max. humidity Product temperature Substrate temperature Nozzle tip Paint output pressure: Thinning: 9,6 Wet (pm) 104 Dry (pm) 50 For use over suitably primed GRP, wood, steel. SEAJET 015 UNDERWATER PRIMER. WHEN APPLYING DIRECT TO SEAJET 117, APPLY WITHIN 48 HOURS. Mixing Mixing ratio Notes Add Component B to Component A whilst mixing. Stir well before use Comp.A: 88 Comp.B: 12 (by volume) * Film thickness and spreading rate depends on application method. In case of brush application more layers may be required to achieve the specified film thickness. - It is important that Component A and Component B will be mixed mechanically, do not add Component B all at once to Component A but in 3-4 portions. - Due to the chemical reaction, the product can thicken but as long as it applied within mentioned pot-life, there will be no problem. - For airless spray application, the product has to be used within 4 hours after mixing using prefilter. After immersion, SEAJET 039 PLATINUM 2-COMPONENTS may exhibit a slight colour change. Surface preparation High pressure wash (±200 bar) to clean the surface. Existing antifouling in good condition: check the SEAJET antifouling compatibility table. If compatible, apply direct. If the old antifouling is not compatible or unknown, apply a barrier coat of SEAJET 015. Existing antifouling in poor condition: remove antifouling. Antifouling should only be wet sanded or chemically stripped. Never burn-off or dry sand old antifouling. Ensure the surface is dry and free of contamination such as salt, grease or oil. Degrease if required. Apply two coats. Apply an extra coat on leading edges, waterline, rudders and stern gear. New application: GRP/Steel: first sand with P100 abrasive paper, remove all dust and apply SEAJET 015 or SEAJET 117 MULTIPURPOSE EPOXY PRIMER. Wood: first sand with P100 abrasive paper, remove all dust and apply SEAJET 015. Aluminium: DO NOT USE SEAJET 039 PLATINUM 2-COMPONENTS on aluminium surfaces.

SEAJET 039 PLATINUM 2-COMPONENTS Drying / overcoating data Notes: Drying times and overcoating intervals will increase with increasing film thickness applied. Before re-coating, always check that the existing paint film is 'through' dry. General information Storage Store the containers in a dry, cool and well ventilated space and away from direct sunlight. Containers must be kept firmly closed. Handle with care. Transportation The product should stay in a securely closed container during transport. Shelf life Min. 2 years @ 20°C Disposal Do not empty into drains, dispose of this material and...