SEAJET 032 PROFESSIONAL
2Pages

SEAJET 032 PROFESSIONAL Product description Seajet 032 Professional is a copper based antifouling for moderate fouling areas. For professional applicators. This economical antifouling is compatible with almost all antifouling and gives a season long protection. Can be used on all substrates except aluminium. Colour Flash point Volume solids % VOC (Theoratical) Pack sizes Mixing ratio Thinner Application methods Conditions SEAJET THINNER A Brush, roller, spray (professional use only)* Spray details Spreading rate Recommended film thickness per coat Substrates Preceding coating Subsequent coating Ambient temperature Max. humidity Product temperature Substrate temperature Nozzle tip Paint output pressure: Thinning: 9,2 Wet (pm) 109 Dry (pm) 50 For use over suitably primed GRP, wood, steel. SEAJET 015 UNDERWATER PRIMER.WHEN APPLYING DIRECT TO SEAJET 117, APPLY WITHIN 48 HOURS. Mixing Before use, stir thoroughly until product is mixed to a uniform consistency. Notes * Film thickness and spreading rate depends on application method, more layers may be required to achieve the specified film thickness. Maximum immersion time after application is 6 months. After immersion, Seajet 032 Professional may exhibit a slight colour change. Colour difference between batches may occur. Mix different batches before use. Surface preparation High pressure wash (±200 bar) to clean the surface. Existing antifouling in good condition: check the SEAJET antifouling compatibility table. If compatible, apply direct. If the old antifouling is not compatible or unknown, apply a barrier coat of SEAJET 015. Existing antifouling in poor condition: remove antifouling. Antifouling should only be wet sanded. Never burn-off or dry sand old antifouling. Ensure the surface is dry and free of contamination such as salt, grease or oil. Degrease if required. Apply two coats. Apply an extra coat on leading edges, waterline, rudders and stern gear. New application: GRP/Steel: first sand with P100 abrasive paper, remove all dust and apply SEAJET 015 or SEAJET 117. Wood: first sand with P100 abrasive paper, remove all dust and apply SEAJET 015. Aluminium: DO NOT USE SEAJET 032 PROFESSIONAL on aluminium surfaces.

SEAJET 032 PROFESSIONAL Drying / overcoating data Notes: Drying times and overcoating intervals will increase with increasing film thickness applied. Before re-coating, always check that the existing paint film is 'through' dry. General information Storage Store the containers in a dry, cool and well ventilated space and away from direct sunlight. Containers must be kept firmly closed. Handle with care. Transportation The product should stay in a securely closed container during transport. Shelf life Min. 2 years @ 20°C Disposal Do not empty into drains, dispose of this material and its...