1. Catalogs
  2. Sea U Experience
  3. TYPE APPROVAL CERTIFICATE - ORCA 866 - PENNEL & FLIPO

TYPE APPROVAL CERTIFICATE - ORCA 866 - PENNEL & FLIPO

TYPE APPROVAL CERTIFICATE - ORCA 866 - PENNEL & FLIPO

TYPE APPROVAL CERTIFICATE - ORCA 866 - PENNEL & FLIPO

Product catalog summary
Product Description: The certificate pertains to ORCA 866, a proofed fabric designed for inflatable crafts, specifically for the hulls of boats. The fabric is made from high tenacity polyester (1670 dtex, 1500 deniers) with an exterior coating of Chlorosulfonated Polyethylene (CSM) and Polychloroprene (CR), and an interior coating of Polychloroprene (CR).
Standards and Compliance: The product complies with International Standards ISO 6185-3:2024 and ISO 6185-4:2011. It has undergone various tests, including low temperature resistance, ozone resistance, tear strength, and cold resistance, as per ISO standards.
Application and Limitations: The fabric is intended for inflatable tubes with a diameter not exceeding 1300 mm and for boats with lengths up to 8 meters (ISO 6185-3) or between 8 and 24 meters (ISO 6185-4). It is not suitable for boats with a single inflatable chamber, buoyancy less than 1800N, or for inflatable liferafts.
Production and Marking: The fabric is produced by PENNEL & FLIPO in Mouscron, Belgium. It must be marked with the trade name, batch number, date of manufacture, and BV Type Approval Certificate number for traceability.
Responsibilities: PENNEL & FLIPO is responsible for informing shipbuilders or subcontractors about the proper fitting, use, and maintenance of the approved equipment. The certificate is valid until 08 Aug 2029, provided no unauthorized modifications are made and the product remains satisfactory in service.
See more

Catalog excerpts

TYPE APPROVAL CERTIFICATE - ORCA 866 - PENNEL & FLIPO-1

Page 1 / 2 Certificate number: 13908/E0 BV File number: FAB 2017/8 Product code: 9065H This certificate is not valid when presented without the full attached schedule composed of 7 sections TYPE APPROVAL CERTIFICATE This certificate is issued to PENNEL & FLIPO MOUSCRON - BELGIUM for the type of product PROOFED FABRICS FOR INFLATABLE CRAFTS ORCA 866 - Polyester High Tenacity 1670 dtex 1500 deniers Requirements: International Standard ISO 6185-3:2024 International Standard ISO 6185-4:2011 This certificate is issued to attest that Bureau Veritas Marine & Offshore did undertake the relevant approval procedures for the product identified above which was found to comply with the relevant requirements mentioned above. This certificate is a renewal of certificate N° 13908/D0 BV expiring on 08/08/2024 This certificate will expire on: 08 Aug 2029 For Bureau Veritas Marine & Offshore, At BV ANTWERP, on 15 Jul 2024, Nele Appels This certificate was created electronically and is valid without signature This certificate remains valid until the date stated above, unless cancelled or revoked, provided the conditions indicated in the subsequent page(s) are complied with and the product remains satisfactory in service. This certificate will not be valid if the applicant makes any changes or modifications to the approved product, which have not been notified to, and agreed in writing with Bureau Veritas Marine & Offshore. Should the specified regulations or standards be amended during the validity of this certificate, the product(s) is/are to be re-approved prior to it/they being placed on board vessels to which the amended regulations or standards apply. This certificate is issued within the scope of the General Conditions of Bureau Veritas Marine & Offshore available on the internet site www.veristar.com. Any Person not a party to the contract pursuant to which this document is delivered may not assert a claim against Bureau Veritas Marine & Offshore for any liability arising out of errors or omissions which may be contained in said document, or for errors of judgement, fault or negligence committed by personnel of the Society or of its Agents in establishment or issuance of this document, and in connection with any activities for which it may provide. The electronic version is available at: http://www.veristarpm.com/veristarnb/jsp/viewPublicPdfTypec.jsp?id=w4xooj7chw BV Mod. Ad.E 530 June 2017 This certificate consists of 2 page(s)

 Open the catalog to page 1
TYPE APPROVAL CERTIFICATE - ORCA 866 - PENNEL & FLIPO-2

ORCA 866 is a coated fabric intended to be used for inflatable/inflated hull of boats. • As per requirements of regulations stated on front page of this certificate. • Intended to be used for inflatable/inflated tube not more than 1300 mm of diameter of boats. • According to the Manufacturer recommendation, the length of the boat should be not more than 8 meter according to the ISO standard 6185-3 or it should be more than 8 m and not more than 24 meter according to the ISO standard 6185-4. • Not intended to be used for boats with one inflatable chamber, and for boats with buoyancy less than...

 Open the catalog to page 2
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.