*mynauticexpo

STEP BY STEP

Product catalog summary

Overview: This document provides detailed instructions for boat repairs using Sea-Line® products, focusing on GRP, steel, aluminum, and wood boat systems. It includes specifications for product application, recommended procedures, and best practices for achieving optimal results.

Specifications:

Epoxy Lightprimer: Apply 1-2 coats above and below the waterline. Thinning ratios vary for brush/roll (5%-25%) and spray (5%-50%). Pot life is 2 hours at 20°C, with a recoat time of 4 hours and a maximum of 5 days.
Polyurethane: Apply 1-3 coats above the waterline. Thinning ratios for brush/roll are 15%-25% and for spray 45%-55%. Pot life is 6 hours 30 minutes, with a recoat time of 72 hours.
Antifouling: Compatible with all types of antifouling paints, both self-polishing and hard.

Procedures:

Surface Preparation: Degrease, sand, remove dust, and degrease again. Wash off salts and impurities with fresh water using Sea-Line® cleaner.
Mixing and Application: Mix products thoroughly until a uniform color is achieved. Only mix enough for immediate use. Use recommended thinners and do not exceed the hardener amount.
Application Conditions: Minimum temperature for epoxy products is +10°C. Apply systems below the waterline 5 cm above the real waterline.

Recommendations:

Use epoxy fillers for hull elements below the waterline.
Apply Sea-Line® epoxy lightprimer before polyester topcoat systems.
Follow technical data sheets (TDS) and material safety data sheets (MSDS) for all applications.

Systems:

Antiosmotic System: For new hulls, apply 1 coat of Epoxy Lightprimer followed by 2-4 coats of Antiosmotic HS Epoxy Primer. No thinning recommended for HS Epoxy Primer.
Osmotic Repair System: Similar to the antiosmotic system, with additional epoxy filler applications as needed.
Steel and Aluminum Boat System: Includes anticorrosion epoxy primer and epoxy fillers for leveling and thick applications.
Wood Boat System: Similar to other systems, with specific recommendations for polyurethane application above the waterline.

Critical Information:

Ensure correct coating thickness (100 μm dtf) for effective antifouling paint operation.
Adhere to specified pot life and recoat times to ensure product effectiveness.

Catalog excerpts

STEP BY STEP boat repairs with Sea-Line®

Open the catalog to page 1

• Correct surface preparation is the condition of good product application. • Degrease the work surface, sand with sandpaper, remove dust and degrease again. Wash off salts and any other impurities with fresh water. Use Sea - Line® cleaner. • Minimum temperature for application epoxy products is +10oC. • Do not exceed the recommended amount of hardener. • Mix contents well until mixture is a solid color. • Only mix enough product for immediate use. • Use only thinners recommended by producer. • Epoxy fillers are the only ones recommended for elements of the hull below the water line. • For epoxy...

Open the catalog to page 2

STEEL AND ALUMINIUM BOAT SYSTEM WOOD BOAT SYSTEM *Special attention should be paid to obtaining a specific coating thickness (100 |jm dtf), which ensures the effective operation of the antifouling paint.

Open the catalog to page 3

STEP BY STEP

STEP BY STEP

Catalog excerpts

All Sea-Line Troton sp. zo.o. catalogs and brochures