Catalogs >
Sea Hawk >
Tropikote Biocide Plus?

Tropikote Biocide Plus?
2Pages

Catalog excerpts

Tropikote Biocide Plus Highest Copper Content w/ Slime Control Hard, Modified Epoxy w/Slime Control Dual Biocide Protection Maximum Copper Exposure Aggressively Combats Growth Same Copper Content for Every Color 2200 Series Product Description Tropikote Biocide with slime resistance is a hard protective bottom paint that produces the most durable finish for long lasting performance. The high loading of cuprous oxide combined with a specially formulated algaecide results in unprecedented resistance to barnacles, algae, slime and other marine and freshwater fouling organisms. It can be applied over most existing hard antifouling paint. Features and Benefits 73.75% is the Highest Copper Content with Slime control available on the market Slime control biocide for controlling soft growth May use on fast or slow moving vessels Colors consistent in every gallon May be applied over most modified epoxy antifoulants One year certified applicator warranty against growth Product Information Application Controls Colors: Black 2245, Dark Blue 2240, Blue 2242, Red 2241 Finish/Sheen: Semi-Gloss Copper Content: 73.75% (all Colors) Slime Control Biocide: 2% Volume Solids: 67% +\- 2% Shipping Weight: 24 Lbs./Gal. Method: This product may be applied by airless and conventional spray, solvent resistant rollers and brushes. Flash Point: 100° F Substrate Temp. VOC: 288 Grams/Liter Typical Film Thickness: Pleasure Craft: 2.5 mils dry film thickness (DFT) per coat, (3.7 mils wet film thickness (WFT)) Commercial Marine: 4.0-5.0 mils DFT per coat by spray application (6.0– 7.5 Mils WFT) Recommended Coats: 2 coats on entire hull and 3 at waterline and other high wear areas Theoretical Coverage: 430 Sq.Ft./Gal. @ 2.5 mils DFT Pleasure Craft Drying time in Hours Touch Min Max Minimum Launch Maximum Launch 73°F (23°C) 2 hr 1 hr N/A 12 hrs 30 days 95°F (35°C) 1 hr 1 hr N/A 12 hrs 30 days Please contact your Sea Hawk representative for Commercial Marine application and overcoating dry times. Note: If the vessel is launched, and then rehauled, air exposure should be limited to 72 hours. If out of the water longer than 72 hours, Tropikote Biocide Plus will oxidize and lose its antifouling effectiveness. Therefore, an additional coat of Tropikote Biocide Plus is recommended after 72 hours of air exposure from haul out time. NEW NAUTICAL COATINGS, INC. 14805 49th Street North • Clearwater, FL 33762 • 727.523.8053 • 800.528.0997 • FAX 727.523.7325 www.SeaHawkPaints.com

Open the catalog to page 1

Surface Preparation Paint only clean, dry surfaces. Remove all grease, oil, wax, or other foreign material by solvent or detergent washing. (SSPC-SPI) Compatibility: For pleasure craft applications, please refer to our Sea Hawk Compatibility Chart to ensure compatibility when applying Tropikote Biocide Plus antifouling paint over existing bottom paint. Tropikote Biocide Plus Hard, Modified Epoxy w/Slime Control 2200 Series Previously Painted Surfaces: Tropikote Biocide Plus is suitable for this substrate. For correct procedures please refer to the Application Guidelines for...

Open the catalog to page 2