Revision date: April 2019 Technical Data Sheet Solvent-Free Semi-Hard Ablative 5400 Series Water-Based Antifouling – Safer for the Environment • Low VOC’s • Long Lasting Semi-Hard Ablative Finish Reduces Paint Buildup • Tests Prove Monterey Outperforms All Other Water-Based Paints PRODUCT DESCRIPTION Monterey is Sea Hawk’s solvent- PRODUCT INFORMATION free antifouling formulation that is Colors: Black 5445, Blue 5442, Dark Blue 5430, Red 5441, Green 5443 designed to give the best protection Finish/Sheen: Semi-gloss against all types of marine fouling, while remaining friendly to the Copper Content: 54.67% (1391 g/l) all colors environment. Monterey is a hard, ablative finish that is easy to apply. It is compatible with most paints on the market and can be applied over most existing bottom paint in good condition. Monterey can also withstand removal from water without affecting its antifouling abilities. Mix Ratio: One Pack Shipping Weight: Black - 21.09 Lbs/Gal (9.56 kg/Gal) Blue - 20.63 Lbs/Gal (9.35kg/Gal) Dark Blue - 20.66 Lbs/Gal (9.37 kg/Gal) Red - 21.22 Lbs/Gal (9.62 kg/Gal) Green - 20.71 Lbs/Gal (9.39 kg/Gal) *All colors are not available in all states Flash Point: N/A VOC: 78 Grams/Liter Typical Film Thickness: Pleasure craft: 2.2 mils (55.88 µ) dry film thickness (DFT) per coat, (5.0 mils (127 µ) wet film thickness (WFT)), 2 coats on entire hull and a 3rd at the waterline and other high wear areas. Pleasure craft (California/Reduced CU2O Leach Rate Application): 1.5 mils (38.1 µ) dry film thickness (DFT) per coat, (3.4 mils (86.36 µ) wet film thickness(WFT)), 2 coats on entire hull. Theoretical Coverage: 320 sq.ft./gal. (29.729 m2) @ recommended film thickness FEATURES & BENEFITS • Low VOC’s and highest grade of cuprous oxide available (more potent active ingredient) • Semi-harder ablative finish (lasts longer on higher speed vessels) (Page 1 of 2) NEW NAUTICAL COATINGS, INC. 14805 49th Street North • Clearwater, FL 33762 • 727.523.8053 • 800.528.0997 • FAX 727.52

Technical Data Sheet • Better color consistency for color matching • Consistent viscosity = better flow and rolling ability • May be applied over other ablative antifoulant paints Cleaning: Clean all equipment immediately after use with water. It is a good practice to periodically flush out spray equipment during the course of the day. Frequency should depend upon amount sprayed, temperature, elapsed time including delay, etc. Safety: Prior to use, obtain and consult the “Safety Data Sheet” for this product for health and safety information. Read and observe all precautionary notices on container...